Maintenance And Care - DT SWISS D 232 Manual De Instrucciones

4. REMOVING / FITTING THE SEAT POST WITH THE QUICKCONNECTOR
The seat post can be removed and fitted in just a few steps with the help of the quickconnector.
1. Screw the cable adjuster on the remote lever in fully to relieve the tension.
2. Remove the remote lever from the handlebars.
3. If present, release the cable clamps on the bike frame.
4. Open the seat post clamp, pull the seat post carefully out of
the bike frame while feeding the cable at the same time.
5. Pull the cable housing on the quickconnector
downwards and detach the cable housing.
6. Detach the cable from the quickconnector.
7. Assembly is in reverse order.

5. MAINTENANCE AND CARE

Task
Full service (to be completed by a DT Swiss Service Center if
necessary): refer to the Technical Manual available at
www.dtswiss.com
Small service (to be completed by a DT Swiss Service Center if
necessary): refer to the Technical Manual available at
www.dtswiss.com
Check the seat post for damage and cracks.
If there is any damage, contact the DT Swiss Service Center.
Check the fastening is correct / check tightening torques.
If the saddle clamp screws have become loose, a medium
strength thread lock can be used.
Check the functionality
Clean with a soft sponge and a suitable cleaner, especially in
the area around the wiper seal.
Do not use high pressure cleaners or aggressive cleaners!
5.1 DISPOSAL AND ENVIRONMENTAL PROTECTION
The statutory regulations shall apply. Whenever possible, avoid creating waste. Waste, especially
carbon, lubricants, cleaners and any other fluids must be disposed in an environmentally compatible
manner.
6. WARRANTY
Warranty conditions can be found at www.dtswiss.com
D 232 - User Manual V2020.02
Interval
Annually or after 200 operating
hours
50 operating hours
more frequently in case of extreme
operating conditions.
Before and after every ride
and after a crash
Before each ride
Before each ride
After each ride
23