Fuse Replacement-Dc Charging Adapter; Troubleshooting Guide - Wagan Tech Solar e Power Case 450 Manual De Usuario

Solar e Power
Fuse Replacement—DC Charging Adapter
The DC Charging Adapter comes equipped with one 15A quick blow fuse inside each plug end.
To replace a fuse, simply unscrew the head of the plug and remove the fuse. If blown, replace
with a 15 amp fuse of the same type and rating.

TROUBlEshOOTing gUiDE

ProBlem
No AC output, Green
LED is not lit, Voltmeter
reads below 10 volts
No AC output, no
displays lit
No AC output, 12 volt
outlet operates, USB
ports operate. Inverter
Switch is ON
12 volt DC outlet
switches on and off
Television interference
Static/noise interfer-
ence in audio system
Run time is less than
expected
Charging light is OFF
when AC Charging
Adapter is connected
DC Charging Adapter
does not work
22
Case 450 by Wagan Tech
™
PoSSiBle CauSe
Battery voltage too low
Excessive AC load
Inverter Switch is OFF
Inverter is not working
DC Outlet is overloaded
Picture breaking up (static)
Sound system has weak al-
ternating current shielding
Solar e Power Case is not
fully charged
Product power consumption
is higher than expected
No AC power at wall
socket
Blown fuse
www.wagan.com
SoluTion
Reduce AC load and charge the Solar
e Power Case battery
Turn ON Switch
Call Wagan Tech Support
Reduce DC load.
Place the Solar e Power Case as far
as possible from the TV, the antenna
and the coaxial cable
TV station may be out of range
Do not use Inverter with low quality
audio AC filtering system
Replace audio system with high qual-
ity noise filtering
Charge using the AC Charging
Adapter.
Check the power or "wattage" rating
and compare with the tables in Bat-
tery Operating Times section of this
manual
Ensure power is available at the wall
socket
Check for and replace blown fuse in
plug.