Rear Panel - Fender Passport Event Manual De Instrucciones

BASS BASS
SUB OUT — Output connection for a powered subwoofer
such as the Fender® PS-512. Set the external subwoofer's
REVERB REVERB
"Crossover Frequency" control to 120Hz. The subwoofer's
"Volume" or "Level" control can be adjusted to give the
desired amount of bass.
PAD PAD
♫
Bass signals require more power than any other signals,
and will quickly max out the Passport System. Connecting a
INPUT INPUT
subwoofer to this jack automatically removes the bass signals
(below 120Hz) from the main Passport amp and speakers,
allowing it to focus on everything except for bass, while the
external Subwoofer handles the bass. This will result in a louder
and better sounding system.
LEVEL
PHONES
Power/Protect LEDs
OUT
PROTECT
POWER / PROTECT — The Power LED will illuminate green
when the Passport is turned on. If the Protect LED illumi-
nates red, the Passport amplifier has shutdown to protect
itself from electrical or thermal trouble. The Passport will
reset itself as soon as the problem has been resolved. If the
Passport will not reset and the Protect light stays red even
after you've tried different power outlets and given it time to
cool down, take it to an authorized Fender Service Center. If
neither LED illuminates when powered on, check the Fuse
in the Power Socket.

Rear Panel

WARNING:
FENDER AMPLIFIER SYSTEMS ARE CAPABLE OF PRODUCING
VERY HIGH SOUND PRESSURE LEVELS WHICH MAY CAUSE
TEMPORARY OR PERMANENT HEARING DAMAGE. USE CARE
WHEN SETTING AND ADJUSTING VOLUME LEVELS DURING USE.
CAUTION:
CHASSIS SURFACE HOT
WARNING:
TO REDUCE THE RISK OF FIRE OR ELECTRIC
SHOCK, DO NOT EXPOSE THIS EQUIPMENT TO RAIN OR MOISTURE
AVIS:
RISQUE DE CHOC ELECTRIQUE NE PAS OUVRIR
AT T E N T I O N :
S U P E R F I C I E D E C H A S S I S C H A U D E
100 -120V ~ 220 - 240V ~
50/60Hz 50/60Hz
ON OFF
CAUTION:
FUSE
T6.3A H TO REDUCE THE RISK OF
FIRE, REPLACE FUSE WITH
250V
SAME TYPE AND RATING
ATTENTION:
UTILISER UN FUSIBLE DE
RECHANGE DE MEME
TYPE ET CALIBRE
FENDER MUSICAL INSTRUMENTS CORP.,
INPUT POWER CORONA, CA U.S.A.
450W
VOLTAGE SELECTOR — Change this setting only if you travel
to a country that requires a different voltage setting.
POWER — Switches the Passport on-off.
POWER SOCKET — Connect to a grounded AC outlet in
accordance with the proper VOLTAGE SELECTOR
BASS BASS BASS
REVERB REVERB REVERB
PAD PAD LINE
INPUT INPUT
INPUT
MONO
OUT SUB OUT
POWER
Laite on liitettävä suojamaadoituskoskettimilla
varustettuun pistorasiaan
Apparatet må tilkoples jordet stikkontakt
Apparaten skall anslutas till jordat uttag
THIS DEVICE COMPLIES WITH PART 15 OF FCC RULES. OPERATION IS SUBJECT TO THE FOLLOWING TWO
CONDITIONS: (1) THIS DEVICE MAY NOT CAUSE HARMFUL INTERFERENCE, AND (2) THIS DEVICE MUST
ACCEPT ANY INTERFERENCE RECEIVED, INCLUDING INTERFERENCE THAT MAY CAUSE UNDESIRED OPERATION.
Use only with supplied
4 ohm speakers
SPEAKER OUTPUTS
US patent No.
LEFT
375W total
4Ω MIN 185W
RIGHT
TYPE: PR 845
SERIAL NUMBER
A PRODUCT OF:
MADE IN CHINA
setting.
BASS
FUSE — To replace a failed fuse, unplug the power cord,
then pry the fuse holder out of the POWER SOCKET
REVERB
use a fuse of the same type and rating.
SPEAKER OUTPUTS — Connect the Passport speakers here
using the cables provided.
PAIR
L/MONO INPUT
TYPE:
RIGHT INPUT
PART NUMBERS:
STEREO INPUT
POWER REQUIREMENT:
FUSE:
DIMENSIONS:
WEIGHT:
Product specifications are subject to change without notice.
This product
is covered by
5,933,507
C US
158744
Specifications
PR 845
6946000000 (120V~, 60Hz)
6946000900 (120V~, 60Hz) DS
6946001900 (110V~, 60Hz) TW DS
6946003900 (240V~, 50Hz) AU DS
6946004900 (230V~, 50Hz) UK DS
6946005900 (220V~, 50Hz) ARG DS
6946006900 (230V~, 50Hz) EU DS
6946007900 (100V~, 50/60Hz) JP DS
6946008900 (220V~, 50/60Hz) CN DS
6946009900 (220V~, 60Hz) ROK DS
6946013900 (240V~, 50Hz) MA DS
450W
T6.3A H, 250V
Height: 23 in (58.42 cm)
Width: 29 in (73.66 cm)
Depth: 11 in (27.94 cm)
44 lb (19.96 kg)
. Only
11