Initial Operation - Magnat MA 1000 Notas Importantes Sobre La Instalación / Certificado De Garantía

oPeRAtIoNAl eleMeNtS AND coNNectIoNS – ReMote coNtRol
• Before using the remote control the supplied batteries must be inserted into the battery compartment
located at the rear of the remote control.
• If the batteries have run out after prolonged use, please replace them (type AAA).
• To prevent causing damage to the remote control please remove the batteries if the device is not
going to be used for a prolonged period.
• Battery disposal: Old batteries are hazardous waste and must be disposed of in accordance with
current regulations.
22 Power
Switches the device on when it is in the standby mode. if the
LED does not illuminate, actuate the power switch located
on the rear of the device. Conversely the device can be
switched from power operation to the standby mode.
23 Display
This button can be used to switch the display off and switch
it back on as required.
24 Input Selecton
these buttons enable direct selection of the individual audio
inputs. The active input is indicated in the display.
25 Volume
increases (5) or decreases (6) the volume.
26 Mute
You can mute the sound using this button. The sound can
be reactivated by pressing this button again.
The non-numbered buttons are reserved for operating the
Magnat CD player MCD 1050 and have no function for the
mA 1000.

INItIAl oPeRAtIoN

• Place the MA 1000 on an even surface. Observe the relevant clearance gaps as specified under
„Important safety instructions".
IMPoRtANt: Do not place any objects on top of the device (magazines, CD/record cases, etc.).
The ventilation slots located on top of the device must be unobstructed at all times!
• Connect your speakers:
Single Wiring:
The stereo speakers (impedance of 4 to 8 ohms) are connected to the rear as follows:
Only use high-quality audio speaker cables with a conductor cross section of min. 1.5 - 2.5 mm².
Strip approx. 10 mm from the cables and twist the ends. Loosen the terminal screws one after the
other and insert the stripped ends into the holes. Re-tighten the terminal screws. Make sure you
pay attention to the correct polarity.
You can also use prefabricated cables with 4mm banana plugs or forked fittings.
Bi Wiring:
The MA 1000 offers the opportunity to operate speakers in a bi-wiring mode by using a second
terminal pair. This means that the woofer and tweeter elements of the speaker are connected to
the amplifier with separate cables.
Also observe the operating instructions for the speakers you are using.
10