Protective Circuit; Tube Replacement; Service And Technical Problems - Magnat MA 1000 Notas Importantes Sobre La Instalación / Certificado De Garantía

• Connect your audio sources to the analogue connections.
• Connect the supplied mains cable to the rear and then insert the other end into a 230V socket.
• Turn the volume knob to the left to a low volume setting.
• Actuate the on/off switch on the rear side, the device is now in the standby mode.
• Switch on the device using the ON/STANDBY button on the front panel or the remote control.
• When the tubes have heated up the device is ready for use.
• Select your desired audio source using the input selector switch.

PRotectIVe cIRcuIt

To ensure maximum protection for the amplifier and the connected speakers the MA 1000 is equipped
with a protective circuit. In the event of a short circuit, overcurrent or DC offset it separates the speaker
outputs from the amplifier. In this case "PRotect" is indicated in the display. The device must be
disconnected from the power supply and the cause of the malfunction determined. Start by checking
the wiring of the speakers. If the malfunction occurs again, please contact a specialist and get the
amplifier and/or the speakers checked.

tuBe RePlAceMeNt

The device has a high quality preamplifier stage which is equipped with two tubes. The tubes have a
very long service life when used under normal operating conditions (min. 20,000-50,000 hours).
If it is necessary to replace the tubes, please refer to a specialist dealer.

SeRVIce AND tecHNIcAl PRoBleMS

If you should encounter any technical problems, please contact your specialist dealer or Magnat Audio-
Produkte GmbH, Tel.: 02234807-0.
SPecIFIcAtIoNS
Amplifier:
Power output:
Rated power 20 Hz – 20 kHz, THD < 1.0%, 4 Ohm
20 hz – 20 khz, thD < 1.0%, 8 ohm
Peak power 1 kHz, 4 Ohm
Frequency response :
CD/Tuner/Aux/Line/Tape 5 Hz – 100 kHz (-3 dB)
20 hz – 20 khz (+/- 0.1 dB)
phono 20 hz – 20 khz (+/- 0.3 dB)
Subsonic filter: 16 hz, 18 dB/octave
Signal to noise ratio:
CD/Tuner/Aux/Line/Tape
phono mm
Phone MC
Input sensitivity/impedance:
CD/Tuner/Aux/Line/Tape
Phono MM
Phone MC
fitted with:
Preamplifier:
Dimensions (wxhxd):
main device:
Main device incl. operational elements/connecting terminals:
Remote Control:
Weight: 11.0 kg
Miscellaneous
mains voltage:
Electricity consumption:
Subject to technical change.
For further information please visit our website: http://www.magnat.de.
2 x 115 W
2 x 80 W
2 x 250 W
11
110 dB (A)
89 dB (A)
77 dB (A)
400 mV / 100 kOhm
2.5 mV / 47 kOhm
0.3 mV / 470 Ohm
2 x 12AU7 / ECC 82
434 x 125 x 330 mm
434 x 125 x 380 mm
47 x 198 x 23 mm
230 VAC / 50 Hz
max. 420 W