Exhaust Filter Changing - Sears Kenmore 116.20812 Manual Del Propietário

wARr, JiNG .......................
Fire andlor Electrical Shock Hazard
Do not operate with a clogged
exhaust filter or without the exhaust
filter or exhaust filter cover installed.
i l,il I I I,I!l',,L',g., r, ....... ,;, . .....
EXHAUST FILTER
HEPA
The exhaust filter cartridge must be
replaced when dirty. Replace the filter when
the entire surface area is covered evenly.
The filter CANNOT be washed as it will
lose its dust trapping ability.
NOTE: Use exhaust filter #20-86880. tn
Canada, #20-86880C.
1. Pull up on
the exhaust fil-
ter cover to
remove from
the motor cover
and lay aside.
Exhaust
2. Slightly push
the exhaust filter
cartridge to the
side, as shown in
the illustration,
and pull up to
remove.
3. Replace the
exhaust filter car-
tridge, carefully Exhaust
positioning it so
that the side
shown in the
illustration goes
down under the
ribs. Then push
the other side
down until it snaps into place. Place the new
filter into the motor cover with the grey
edge down.
Exhaust
4. Replace the
exhaust filter
cover by engag-
ing the two tabs
on the rear and
pushing down in
front until it
snaps closed.
Always follow all safety precautions when
cleaning and servicing the Power-Mate e.
l
wARNING .............
Electrical Shock Or Personal Injury
Hazard
Disconnect electrical supply before
servicing or cleaning the unit.
Failure to do so could result tn elec-
trical shock or personal injury from
cleaner suddenly starting.
ii I , II ,i I iiililll , i,iiiiiii1,,i,, ,
16