Tabla de contenido
Publicidad
Idiomas disponibles
Idiomas disponibles
PRINCIPLE OF OPERATION
4
5
6
3
2
1
Before switching the device to the power supply, make sure that the thermostat knob is switched off, this
means, in the "OFF" position.
Place the grate on the bottom of the container. Place the desired amount of hot-dog sausages on the grate
and then pour an appropriate quantity of water. Do not exceed the MAX level marked inside the container.
Switch the device on using the ON/OFF buttons (the switch will light up) and then use the thermostat to
set the desired temperature. The control lamp lights up during the heating process. Once the water reaches
the desired temperature, the control light will switch off. When the water temperature decreases by a
few degrees, the device will automatically activate the heating process to return the water to the pre-set
temperature. When the unit is no longer in use, set the thermostat to „0" and turn the device off using the
ON/OFF switch (the switch will no longer be illuminated).
ATTENTION! When the device is switched on, some elements can reach high temperatures. There is a
risk of burning! Do not touch these elements with bare hands! To remove the sausages from the device use
gloves or appropriate kitchen utensils.
TRANSPORTATION AND STORAGE
During transport, the machine should be protected from shaking, falling and turning upside down. Store it in
a properly ventilated place with dry air and without any corrosive gas.
CLEANING AND MAINTENANCE
•
Always unplug the device before cleaning it and after each use.
•
Use cleaner without corrosive substances to clean surface.
•
After cleaning the device, all parts should be dried before reusing it.
•
Store the unit in a dry, cool place, free from moisture and direct exposure to sunlight.
•
Never spray the device with water jets.
CHECK REGULARLY THE DEVICE
Check regularly whether the device is damaged. If it should be damaged, please stop using it immediately and
contact your customer service to solve the problem.
What to do in case of a problem?
Please contact your customer service and prepare the following information:
•
Invoice number and serial number (the latter is to be found on the technical plate on the device).
•
If relevant, take a picture of the damaged, broken or defective part.
•
It will be easier for your customer service clerk to determine the source of the problem if you give a
detailed and precise description of the matter. Avoid ambiguous formulations like "the device does not
heat", which may mean either that it does not heat enough or that it does not heat at all. The more
detailed your information, the better the customer service will be able to solve your problem rapidly
and efficiently!
CAUTION: Never open the device without the authorization of your customer service. This can lead to
a loss of warranty!
10
1.
ON / OFF switch
2.
Heat on control light (HEAT)
3.
Thermostat
4.
Lid
5.
Grate
6.
Power cable
Rev. 20.04.2017
INSTRUKCJA OBSŁUGI
R C H W- 1 0 0 0
expondo.de
Publicidad
Tabla de contenido
