Electrical Characteristics - Weelko WKB005 Manual De Instrucciones

CAUTIONS
• Within 24 hours of receiving the treatment, it is
recommended to use sun protection cream. Consult
your beautician about which other cosmetic products
can be applied on your skin.
• Patients suffering from anaphylaxis, severe acne,
hyper-sensitive skin or blood circulation problems
should consult a doctor before using this device.
• If the patient notices some discomfort during the
treatment, stop it immediately.
TECHNICAL SHEET
Weights and sizes
Working characteristics

Electrical characteristics

MAINTENANCE
• Do not clean the device when it is turned on.
• Use a clean, dry cloth to clean the device. You can
use a slightly damp cloth to clean off stubborn dirt or
stains.
• To clean the hydrodermabrasion handle, start with
bottle C and select the maximum suction intensity.
Press "Start" and keep a finger on the head for 5-10
seconds. Remove the head and repeat the movement
8-10 times. When bottle C is clean and empty, fill
bottles A and B with warm water and repeat the same
action to prevent tubes and handles blockage.
Afterwards, extract the head and clean it with a cloth
to remove any kind of dirt. You can also soak the heads
in alcohol or disinfectant solution for a minute.
• To clean the spray pipe, fill the pipe container with
warm water, press "Start" and spray all the warm
water contained inside.
• Use a damp cloth to clean the other probes and
handles after each use.
Packing size (cm)
Gross weight (kg)
Product size (cm)
Screen size (inches)
Ultrasound Freq.
Bipolar RF Freq.
Suction power
Water flow power
Vacuum pressure
Rated voltage
Frequency
Rated power
43x45,5x31
9,5
26x40x38
7"
1 MHz
2 MHz
650 cm/hg
30 l / h
90 Kpa
230 V
50Hz/60Hz
160 W