Troubleshooting - SmartBidet SB-3000 Manual Del Usuario

Trouble Shooting
9

Troubleshooting

The nozzle
does not spray
The unit is not
operating
Water is leaking
The washing water
pressure is weak
The washing water is
not warm
The seat and dryer is
not warm
20
Problem
1. The water tank is not filled.
if the water tank is filled, water is
supposed to come out when pushing
the drain button
2. The water supply valve is closed.
3. Freezing inside the main unit or the
water supply pipe
1. Disconnected the power cord.
2. The seat is not occupied.
3. The battery of remote controller is
exhausted.
1. Check the water supply system
1. The water pressure level is set to "LOW".
2. The strainer is clogged.
1. The water temperature is set to "LOW"
2. Continuous operation has depleted
the supply of warm water.
1. Turn Off the energy saver. If it is on, the
seat and water temperature are
maintained at 86.9˚F.
Solution
1. Wait about one minute.
2. Press the desired washing button once
again.
3. Open the water supply valve.
4. Heat the room (for about two hours).
Operating the unit while parts are
frozen will cause a malfunction.
1. Connect the power cord.
2. Check the power supply system in
your house.
3. Occupy the seat (The unit has an
occupied skin sensor).
4. Replace the battery.
1. If water is leaking from the main unit,
call the service center or the place you
purchased unit.
1. Set the water pressure to "HIGH"
2. Clean the strainer.
1. Set the water temperature to "HIGH"
2. Wait about three minutes.
1. Set the seat & dryer temperature to
"HIGH"