Correct Use; Safety Instructions - Kerbl FastHeat Digital Instrucciones De Uso

Instructions for Use - FastHeat Digital
EN
1. General
These operating instructions comprise instructions for use and safety information. Please read the instructions
carefully and note the regulations and relevant information before putting the device into operation. Please keep
these operating instructions in a safe place for later use!

2. Correct use

The calf milk heater FastHeat Digital is intended for warming milk and feed prepared using water. The calf milk
heater must not be used for other purposes, in particular to prevent the freezing of water in feeding troughs and to
warm up corrosive liquids. In the event of incorrect use or modifications to the device, the manufacturer's warranty
and liabilities shall be deemed invalid.
The function of the calf milk warmer FastHeat Digital has been optimised for use in cylindrical containers with an
average diameter of max. 22 cm and for volumes of liquid of up to 10 litres. In the event of any deviating conditions,
a longer heat-up time may be required and there may be temperature deviations.
The FastHeat Digital device cannot be used as a temperature measurement device. The FastHeat Digital device is a
calf milk heater which adapts itself to the actual volume of liquid to be heated as a result of an intelligent
measurement and evaluation process.

3. Safety instructions

CAUTION!
Hot surfaces and defective connection cables.
Risk of burns, electrical shock, fires and short circuits.
• Do not place device on objects or surfaces that are sensitive to heat.
• Ensure that the container for the liquid to be heated is made from a heat-resistant material.
Do not use any synthetic material containers.
• Only operate the device in the liquids it is intended for.
• Do not allow electrical supply cables to come into contact with hot surfaces, heat, oil or sharp edges.
• Do not pull on the electrical supply cable to unplug or transport the device. Hang up electrical supply cable on the
integrated cable holder (5) when the device is not in use.
Risk of physical injury and material damage if used incorrectly!
• Ensure that the voltage specified on the type plate matches the voltage of your power source.
• The device may only be connected to mains sockets which are isolated separately via a 30 mA circuit breaker (FI).
• Do not use any multiple sockets. This is a very powerful high performance device.
• Before each use, check that the device, the display film and the power cable in particular are intact.
Do not operate the device if a component is defective.
• Never operate the device without supervision.
• Always keep the device in a safe, dry place out of the reach of children.
• Never remove the device type plate as well as the film on the display and housing.
• National and international safety, health and occupational safety regulations must be observed and complied with.
• When the device is switched on, the liquid to be heated may not be touched.
• Do not operate the device near explosive substance or atmospheres at risk of explosion.
• Regularly check the device for leaks (seals, cable conduits and screw attachments). Neglecting this check can
result in significant danger.
• The device must not be operated via an external timer or a separate remote action system.
12