TUCKY -21 Manual De Instrucciones página 5

OPERATING INSTRUCTIONS
Charge Tucky
- Before using Tucky for the first time, charge Tucky with the supplied cable 6 by connecting it to a computer
5V USB port until the LED turn off (about 2 hours). The autonomy after a full charge is 5 days.
Install the application and create an account
- Download the «Tucky» application from the Apple Store or Google Play Store.
- Create an account by following the instructions, then create one profile per patient.
Note: the data are stored in a certified health data cloud.
Associate Tucky with a patient profile
- Turn on Tucky by pressing the On/Off 2 button; LED 4 will blink for 2 seconds (6 times).
- In phone / tablet settings, activate the Bluetooth® function.
Notes: on iPhone, Tucky may not appear in the list of detected Bluetooth® devices. Simply enable
Bluetooth®, then exit from iPhone settings.
- In the application, select a profile, approach Tucky to the phone / tablet, press the "Associate" button and
accept authorization requests. A temperature is displayed in the banner.
Note: once associated, Tucky reconnects as soon as it's within signal range.
Apply ADH-21 adhesive to Tucky A
- Remove the small part of the paper backing and peel the adhesive 7 from the remaining part. Stick it on
Tucky's front side, making sure probe edges are covered. Then remove both parts of the clear film.
Place Tucky under the armpit
- To place Tucky, observe the following points:
* The micro-USB port 5 must be oriented downwards, with strip-cap 3 closed and sensor 1 facing the skin,
* Tucky must be positionned as high as possible under the right armpit.
Notes: if axillary hairs are present, shave the area before applying the device. In case of heavy sweating,
it is possible to improve Tucky hold by adding a single-sided adhesive strip over it.
- For a better temperature measurement, wear light clothing and wait about 15 minutes with the arm closed
until the temperature stabilizes.
Monitor the data wherever you are (2 use cases)
- Below 10m, use the phone / tablet connected to Tucky via Bluetooth®.
Notes: if Bluetooth® connection is lost, the application tries to reconnect automatically. Tucky will
continue to record the temperature (for 8 hours maximum) and will synchronize with the application as
soon as the connection is re-established.
- Above 10m, two phones / tablets connected to the same account are required.
* One must be connected to Tucky via Bluetooth®. It automatically relays information via Internet to the cloud
(see "Data Protection"), making them accessible to other devices.
* The other one displays data from the cloud without distance limit. A cloud icon on the app indicates this.
Notes: verify that alerts work and are audible by activating "Test alert" on the application.
There is no limit concerning the number of people which can monitor remotely data of the same account.
A
B B
5