Using Tally; Tally Port Pin Connections - Blackmagic Design SmartView Duo Manual De Instalación Y Funcionamiento

You can manually add a SmartView or SmartScope
monitor to the list of connected monitors by clicking the
'plus' icon and entering the monitor's IP address

Using Tally

Tally Port Pin Connections

It is not necessary to connect the tally port of SmartView or SmartScope and you can skip this
section if you do not intend to use the tally feature.
Each SmartView and SmartScope screen features independent tally borders in red, green
or blue which can be used to indicate the status of a video signal such as on-air, preview
or recording.
The 9-pin D-sub tally port accepts contact closure signals from switchers and automation
systems. Please refer to the accompanying tally pin connections diagram for information
about wiring the tally port for use with your switcher or automation system.
The 9-pin D port wiring description is printed on the rear of the unit showing contact closures
to display red, green or blue tally borders on each independent monitor.
SmartView Duo showing green and red tally borders
Using Tally 27