Intermatic Talento 400 Serie Instrucciones De Uso página 10

Safety precautions
· The connection and installation of electrical devices may only be carried out by a qualified
electrician.
· Interventions in and changes to the device result in the voiding of the warranty claim.
· Observe your national regulations and the respective safety provisions.
· Fixed and flexible conductors of up to 10 mm
· Flexible cables with a cross-section ≤ 1 mm
General information
· Deactivation commands take priority over activation commands.
· If the power supply is correct, the dots shown between the hours and minutes (HH:MM) are
displayed permanently. The dots flash if the power supply is interrupted.
· If there is no power supply, the position indicator display goes out after 2 minutes.
· The whole display flashes the battery needs to be changed for up to 2 weeks to warn that.
Installation on DIN rail
2 may be attached to the external terminal clips.
2
should not be attached.
Terminal diagram
5 6 7
1 2 3
C1
C2
L
5 6
1 2 3
N
C1
10
L
N