Chapter -7: Tips For Saving Energy - Sharp SJ-L2350E3I Manual De Uso

CHAPTER -6: TROUBLESHOOTING
If humidity builds up inside the cooler;
• Are all food packed properly? Are the containers dried before placing them in the fridge?
• Is the ridge door opened frequently? Humidity of the room gets in the fridge when the doors are opened.
Humidity build up will be faster when you open the doors more frequently, especially if the humidity of the room
is high.
• Building up of water drops on the rear wall after automatic defrosting is normal. (in Static Models)
If the door is not opened and closed properly;
• Do the food packages prevent closing of the door?
• Are the door compartments, shelves and drawers placed properly?
• Are door joints broken or torn?
• Is your fridge on a level surface?
Recommendations
• In instances of a power cut unplug the appliance. This prevents damage to the compressor. You should delay
plugging in 5 – 10 minutes after you regain power supply. This will avoid damage to components.
• The cooling unit of your refrigerator is hidden in the rear wall. Therefore, water droplets or ice may occur on the
rear surface of your fridge due to the operation of the compressor in specified intervals. This is normal. There
is no need to perform a defrosting operation unless the ice is excessive.
• If you will not use your fridge for a long time (e.g. in summer holidays) unplug it. Clean your fridge according to
chapter cleaning and leave the door open to prevent humidity and smell.
• If the problem persists after you have followed all the instructions above, please consult an authorised service
provider.
Conformity Information
• This appliance is designed for use at an ambient tem-perature within the 16°C - 38°C range.
• The appliance is designed in compliance with the IEC60335-1 / IEC60335-2-24, 2004/108/EC standards.

CHAPTER -7: TIPS FOR SAVING ENERGY

1. Always allow foodstuffs to cool before storing in the appliance.
2. Thaw food in the fridge compartment, this helps save energy.
EN -10-