MZ electronic MZBC 2460 Instrucciones De Uso página 15

Connections
To carry out electrical connections unscrew the three M3 fastening
screws that you will find on both sides and in the centre of the panel.
You can now remove the lower panel. Do not remove the main cover.
The appliance must be connected with a three-pole cable (of at least 2,5
sq. mm) to the AC network. Verify that the line voltage rating is 230V
before connecting the appliance. Make sure there is a switch available
that can section the power feed line of the battery charger.
Caution
CUT OFF THE VOLTAGE BEFORE CARRYING OUT
THE CONNECTIONS AND MAKE SURE THE
BATTERIES ARE NOT CONNECTED.
There is a terminal board on the
lower part of the appliance
which must be used for the AC
power feed cable. The section of
the power feed cables must be
at least 2,5 mm².
Connect the 230 V power feed
line to the L and N terminals
(the brown and the blue cable)
(see picture).
Once you have completed the connection to the network, connect the
batteries.
MZBC_2460
English
15
Rev. 02– 2015