Motor Safety Filter Changing - Sears Kenmore Kenmore 116.29612 Manual Del Proprietário

Tabla de contenido

Publicidad

Idiomas disponibles

Idiomas disponibles

1. Unplug cord from wall outlet, DO NOT
drip water on cleaner.
2. Clean exterior using a clean, soft cloth
that has been dipped in a solution of mild
liquid detergent and water, then wrung dry.
Wipe dry after cleaning.
3, To reduce static electricity
and dust build-
up, wipe outer surface of cleaner and
attachments.
1
CAUTION
Do not use attachments
if they are
wet.
Attachments
used in dirty
areas, such as under a refrigerator,
should
not be used on other
surfaces until they are washed.They
could leave marks.
Check motor safety filter occasionally
and
change when dirty.
Electrical Shock Hazard
Unplug power cord from electrical
outlet.
Do not operate the cleaner
without the motor safety filter.
Be
sure the filter is dry and properly
installed to prevent motor failure
and/or electrical
shock.
Remove the bag as outlined
in the BAG
CHANGING
section.
MOTOR SAFETY
FILTER
ELECTROSTATIC
This white and grey filter must be replaced
when dirty° It should be replaced
regularly
depending
on use conditions.
The filter
CANNOT
be washed as it will lose its
dust trapping
ability,
NOTE: Use motor safety filter #20-86883.
In Canada, #20-86883C,
1. Lift the rubber
retainer and pul!
out motor safety
filter as shown.
2, Replace the fil-
ter, white side out,
by sliding it back
into place under
the ribs in the bag
cavity. Tuck filter in
so that it fits com-
pletely under the
rubber retainer.
3, Replace the bag as outlined
in the BAG
CHANGING
section.
!
NEVER REUSE A DUST BAG. Very
fine materials, such as carpet fresh-
ener, face powder, fine dust, plaster,
soot, new carpet lint, etc. can clog
the bag and cause it to burst before
it is full and may cause damage to
vacuum motor.
Change bag more
often when vacuuming
these
mated-
als,
15

Publicidad

Tabla de contenido
loading

Este manual también es adecuado para:

Kenmore 116.29712Kenmore 116.29713

Tabla de contenido