Sears Kenmore Kenmore 116.29612 Manual Del Proprietário página 20

Review this table to find do-it-yourself solutions for minor performance problems, Any ser-
vice needed, other than those described in this owner's manual, should be performed by
an authorized Sears Service Center_
WARNING
Electrical Shook Hazard
Disconnect electrical supply before servicing or cleaning the umt.
Fa,lure to do so could result in electrical shock or personal injury.
Cleaner won't start,, t.
2,
3.
PoorJobof dirt t,
pick-upo 2.
3_
4.
5.
6.
7o
B.r
9.
10.
Cleanerstarts but 1o
cuts off. 2.
3,
Power-Mate ' _'will not 1,
un when attached°
2
3.
4.
5.
Constantgreen gght on 1.
in dirt sensor, 2.
Any, some, or all red lights 1o
in dirt sensor bum and never
1. Plug in |I_mly,push ON/OFF switchIo ON
2, Reset etmuitbreaker" or replace luse
Unpluggedat walloutlet.
Tripped cimuit breaker/blownfuse
at household service panel
Loosehoseelectrica_ c onnections, 3,
FuIF or clogged duelbag 1.
Clogged airliow passages 2,
Dirty Inters 3_
Wrong pile height setting 4.
Open suction control 5,
HoIa in hose 6.
Worn Power-Mate ® agitaIor 7.
Worn or brokenbelt B & g.
Dirty agitalor or endcaps
Canister hood open. 1O,
Hoseor hoodelectricalconnectbns 1.
Tripped ovedoad protector i n 2,
Power-Mate =
Tripped overload protector 3.
incanister
Power-Mate _ 'connectbns 1
unplugged
Wornor brokenbolt 2 & 3
Dirtyagilatoror end caps
Tripped ovedoadproteclerin 4.
power-Mate ®
Bwilch not in CARPETposition, 5,
Did passageIs clogged 1.,
Lensesare dtriF 2,
Dirt passageIs clogged 1,
Swilch not inCARPETposition 1.
No power to sensorboard. 2.
Fullor dogged dust bag 1,.
Dirty fl!ters 2,
Blockedairflow passage 3.
CerlalnaUachmenttools 4,
Wrong pile heightsetting 1.
Suctionlog strong 2.
Burned out light bulb. 1,
Dtrtypower cord 1.
CordJammed 2_
Wrongvacuuming pattern 1,
Reconnecthose ends, (page7).
Changebag, (page 14)
Clear airflow passages, ( page 14)
Changeglints, (page 15-16)
Adjustsetting.(gage9).
Adjust control, (page 12)
Replace hose
Changeagitator. (page lg).
See BELTCHANGINGAND AGITATOR
CLEANING,(pages 17-1B)
Close and taIchhood,
Checkconnections, reconnect hoseends.(page7)
Removeany itemsthatmay be caught
or jammed, t hen reset if cleanerstars
and stopsagain, cleanagitalor and endcaps,
thenrese!,(pages 12, 17-1B)
Turnoff andunplug the vacuum fromougatand
wait approximately50 minutesand plug lhe vacu-
um In, turnback on 10see If the protecfor h as
reset,(paget3) Change dust bag, clear aidtow
blockage,(page12)
Plug isfirmly, ( page 6)
SeeBELTCHANGINGAND AGITATOR
CLEANING,(pages '_7-tB)
Checkagitatorarea for excessivelint
build, up or jamming. Clean agitelor and
endcaps,thenreset,(pages 12. 17-18)
Moveswilch toCARPET position, ( page B).
Checkfordogs In Bit passages. (page 14)
Clean lenses, (page I0)
Checkfor clogsinair passages, (page 14)
turn green.
No green or red dirt t° Moveswitch toCARPET posilion, (page 8)
sensor lights. 2. Taketoyour nearestSears ServiceCenter.
EiectronfolMechenlael 1_ Changebag, (page 14).
Bag,Hose Check Indicator 2,. Changefillers,(page t 5-t 6)
activates° 3. Clearblockage from airflow passage.(page 14)
4. This is normal.Light should go og
whenfool Is removed.
Cleaner picks up moveable 1. Adjustse!ttng, (page g)
rugs -or- Power+Mate ® 2. Open suclion control(page ! 1)
}nshes too hard,
Light won't work. 1. Changelight bulb, (pagetB).
Cord won't rewind, 1, Clean the power cord
2, Puffout cordand rewind
Cleaner leaves marks on carpet, 1., SeeVACUUMINGTIPS, (page 9)
20