Tabla de contenido
Publicidad
Idiomas disponibles
Idiomas disponibles
TO REMOVE BELT
CAUTION
When you remove the end caps, a
small metal washer on each end
may come off. DO NOT lose these
two metal washers.
TO CLEAN AGITATOR:
NOTE: In order to keep cleaning efficiency
high and to prevent damage to your vacu-
um, the agitator must be cleaned every time
the belt is chan eg#dd.
The agitator must also be cleaned accord-
ing to the following schedule:
Vacuum Use
HEAVY
-
(used daily)
MODERATE
-
(used 2-3 times/week)
LIGHT -
(used 1 time/week)
Clean Agitator
every week
every month
every 2 months
Remove any dirt or debris tn the belt path
area or in the brush roller area.
Carefully remove any string or debris
located on the agitator, end caps, wash-
ers or agitator shaft.
IMPORTANT
Replace the
washers and
the end caps.
See the explod-
ed view for cor-
rect
assembly.
Disconnect
cleaner from electrical
outlet.
Check and remove hair, string and lint build-
up frequently
in the Power-Mate ® agitator
and end cap areas. If build-up becomes
excessive, disconnect
Power-Mate ® from
wand and follow the steps below.
3. Turn Power-
Mate ® right side
up. Press handle
release pedal and
lower the swivel
Lift rear latches up.
1. Turn Power-
Mate e upside
down_
2. Unscrew the
two (2) Power-
Mate ® cover
screws,
4. To remove cover,
grasp the sides and pull
out.
5. Depress
tabs on rear of
agitator cover
and rotate
forward to
release from
the Power-
Mate ® baser
End Cap
Tabs
Agita_r
Cover
6. Lift agitator
assembly out
and remove
worn belt.
7. Slide end caps
off to check and
clean end cap
areas. See
AGITATOR
ASSEMBLY
for
picture of complete
agitator assembly.
EndCap
17
Publicidad
Tabla de contenido
