iSymphony V1BLUE Manual De Usuario página 5

Connect the Wireless iPod Dock to Power
3
This AC adapter operates on AC 120V/60Hz.
The included AC adapter is for use with
!
this iPod dock only. Do not use it with
other equipment.
When the iPod dock is not going to be
used for a long time, disconnect the AC
adapter from the AC outlet.
Select the Correct iPod Dock Adapter
4
When connecting an iPod to this iPod Dock, please ensure that the correct adapter plate is used.
!
FAILURE TO DO SO MAY RESULT IN DAMAGE TO THE iPod.
This iPod Dock comes with 4 removable dock adapters. Using the
correct adapter ensures the proper fit for your iPod and helps to
reduce the stress on the connector when operating the iPod.
NOTE: The adapter for iPod nano is already installed in the dock.
To place a dock adapter:
1. Refer to the compatibility table on page 39 and select the
correct dock adapter for the iPod.
2. Place the proper adapter into the dock and press it into
position. The adapter will only go in one way. The iPod
dock connector should fit through the opening in the
bottom of the adapter.
3. Carefully align and then gently insert the iPod into the
dock. (The iPod must not be in a case or "skin").
4. To remove a dock adapter, first remove the iPod, then
grip the insert and pull gently upwards.
To "DC IN
10V" jack
8
Install Batteries into Remote
5
Insert two AAA batteries into the remote control
while observing the correct (+) and (-) polarities
as shown below .
To AC Power on the Main Unit
6
outlet
Press the STANDBY /
page 51
to for setting the clock.
For setup of Bluetooth connections, refer to
To connect optional components see section Connecting External
page 51.
Devices
For setup of wall mount refer P42
button. The main display briefly shows "HELLO" then "AM 12:00". Please refer
page 29.
to page 53.
9