Tabla de contenido
Publicidad
Idiomas disponibles
Idiomas disponibles
IMPORTANT REMARKS
For any installation problems please contact Key Automation S.p.A. TEL. (+39) 0421 307456
Key Automation S.p.A. has the right to modify the product without previous notice; it also declines any responsibility to
damage or injury to people or things caused by improper use or wrong installation.
Please read this instruction manual very carefully before installing and program-
ming your control unit.
• This instruction manual is only for qualified technicians, who specialize in installations and automations.
• The contents of this instruction manual do not concern the end user.
• Every programming and/or every maintenance service should be done only by qualified technicians.
AUTOMATION MUST BE IMPLEMENTED IN COMPLIANCE WITH THE EUROPEAN REGULA-
TIONS IN FORCE:
EN 60204-1 (Machinery safety. electrical equipment of machines, part 1: general rules)
EN 12445 (Safe use of automated locking devices, test methods)
EN 12453 (Safe use of automated locking devices, requirements)
• The installer must provide for a device (es. magnetotermical switch) ensuring the omnipolar sec-
tioning of the equipment from the power supply. The standards require a separation of the contacts
of at least 3 mm in each pole (EN 60335-1).
• The plastic case has an IP55 insulation; to connect flexible or rigid pipes, use pipefittings having
the same insulation level.
• Installation requires mechanical and electrical skills, therefore it shall be carried out by qualified
personnel only, who can issue the Compliance Certificate concerning the whole installation (Ma-
chine Directive 2006/42/CEE, Annex IIA).
• The automated vehicular gates shall comply with the following rules: EN 13241-1, EN 12453, EN
12445 as well as any local rule in force.
• Also the automation upstream electric system shall comply with the laws and rules in force and be
carried out workmanlike.
• The door thrust force adjustment shall be measured by means of a proper tool and adjusted ac-
cording to the max. limits, which EN 12453 allows.
• We recommend to make use of an emergency button, to be installed by the automation (connect-
ed to the control unit STOP input) so that the gate may be immediately stopped in case of danger.
• The appliance is not to be used by children or persons with reduced physical, sensory or men-
tal capabilities, or lack of experience and knowledge, unless they have been given supervision or
instruction.
• Children being supervised do not play with the appliance.
INDEX
16
16
17
17
18
18
19
19
20
20
21
26
28
28
Publicidad
Capítulos
Tabla de contenido
