SRAM Rock Shox Reverb Bleed Kit Manual Del Usuario página 12

English
1
exTeND THe seATpOsT
Push the remote actuator to extend the seatpost to its full
height.
Turn the speed adjuster on the remote counter-clockwise until
it stops.
2 clAMp THe Bicycle iNTO A RepAiR sTAND
To clamp a Reverb equipped bicycle into a bike stand,
loosen the seatpost binder bolt/quick release at the frame.
Raise the seatpost to the Minimum Insertion line then
tighten the seatpost binder bolt/quick release to the frame
manufacturer's recommendation. You may need to detach
the hose from some of the cable guides in order to raise
your seatpost to the Minimum Insertion line. Do not exceed
6.7 N∙m (60 in-lb).
Clamp the seatpost into the bike stand just below the top
cap. Do not clamp the seatpost by the top cap or allow the
hose to be clamped as this may damage the seatpost.
12
BleeD pROceDURes
Reverb Bleed Kit User Manual
95-4215-006-000 Rev A