Troubleshooting - Gardenline GH18N Manual Del Usuario

Outdoor Insect Killer
Cleaning
As the unit kills insects, most of the insect debris will
fall into the bug collection tray. Some debris will be left
on the grids and over time will reduce the effectiveness
of this device. Make sure to regularly clean the grid to
achieve maximum effectiveness. Regularly check and
brush off any insect debris you may see.
1. Unplug unit and remove it from its hanging position.
2. Remove bulb while cleaning to prevent any damage
to the bulb. See instructions in "Changing Bulbs"
section on page 7.
3. Using a small brush, gently remove insect debris from
outer casing and inner grid.
4. Compressed air may be used to safely clean out your
unit.
5. Never use water to clean your unit as water could
damage the inner electrical components.
6. Once the unit is clean, replace the bulb and return
the unit to the desired position and connect to a
power source.
8
service@801service.net
Maintenance Outdoor Insect Killer

Troubleshooting

Unit will not light, no apparent
grid voltage.
Unit appears to be working properly
but insect population does not seem
reduced.
Unit is constantly arcing (sparking).
AFTER SALES SUPPORT
AFTER SALES SUPPORT
866 558 8096 866 558 8096
Problem
•
•
•
•
•
Clean the unit per the instructions in
this manual . The unit will arc upon
plug-in and then stabilize. This is
normal.
Troubleshooting
Solution
Make sure the unit is
plugged into working
outlet.
Check bulb to make sure it
is seated properly. Replace
bulb if necessary.
Check surrounding area
for sitting water. Insects
breed in these areas and
should be eliminated at the
source.
Allow more time. It will
take some time for insects
to find the unit and also for
there to be an impact on
their reproductive cycle.
Try moving the unit to
another area of the yard.
If you are in between the
unit and and the source
of the insects, they will
have to fly by you to get
to the unit and you may
actually notice an increase
in insects.
9
service@801service.net