Installation Tools; Electrical System Setup; Installing And Adjusting The Leaves - KEY WIND Manual De Instrucciones

TABLE OF FASTENERS FOR MOUNTING SURFACE TYPES
Mounting surface materials
Steel
Aluminium
Aluminium
Reinforced concrete
Plasterboard/hollow bricks
Solid wood

INSTALLATION TOOLS:

4 mm, 5 mm; Spanner 8 mm, 10 mm; Set of bits, drill, electric

4.2 - Electrical system setup

Looking at the automation box, all cables must enter from the far
right, with 3 m surplus cable.
1. Function selector (screened cable 8 x Ø 0.22 mm)
2. Pushbutton control, if installed (cable 2 x Ø 0.22 mm)
3. Remote key or password control unit (cable 4 x Ø 0.22 mm)
4. Power supply cable (Neutral, Live, Ground) (cable 3 x Ø 1.5 mm)
5/6. Safety photocells (cable provided, to be wired inside the beam)
7. Pulse control devices (radar) (cable 4 x Ø 0.22 mm)
8. In entrances with two sliding leaves with anti-panic breakout sy-
stem (fixed at the sides or to the wall) the automation must be in-
stalled on the outside to allow break-out in any position; photocells
must therefore be installed to ensure a motor STOP in the event of
breakout.
If there are semi-fixed side panels next to the sliding leaves which
also have breakout function, instead of the STOP photocells it is suf-
ficient to install two electrical contacts which break the circuit and cut
out the sliding doors if the semi-fixed side panels are opened (which
will always occur in breakout of the sliding doors).
N.B. If just one pair of photocells is installed, they must be
mounted 50 cm above the ground. If two pairs of photocells
are installed, they must be mounted 20 and 100 cm above the
ground.

4.3 - Installing and adjusting the leaves

DOUBLE DOOR
SINGLE DOOR
Minimum thickness
5 mm
6 mm
3 mm
>120mm in thinnest point
Must be reinforced with 5 mm steel structure
50 mm
Torque wrench 3-15 Nm; Allen key
M8
M8
M8 threaded inserts
Expansion plugs Ø 14mm, M8 hex. head screw
M8
Hex. head anchor bolt 13mm Ø 8mm
screwdriver; Screwdrivers, cross-head (small, medium), straight
(small), electrical scissors.
8
PL
LA LA
LE
LT
PL
LA
LT
Screw type
7
5
6
EN
8
4
3
2
1
23