Adjusting The Pa011 - Pa011L Electric Lock And Manual Release Device - KEY WIND Manual De Instrucciones

EN
Adjustments can be made to align the leaves; back off the two
screws that secure the traction devices and move the devices to
the right or left along the slots.
Once adjusted, tighten the Allen screws (E) firmly.
To adjust the belt tension, undo the Allen screws F of the pulley
slighting, then screw down (to tighten) or back off (to slacken)
the hexagonal screw G.
Once the tension is correct, remember to tighten the screws F
firmly.

4.9 - Adjusting the PA011 - PA011L electric lock and manual release device

If the electric lock is not installed, move on to the next section.
Otherwise, follow these instructions closely:
On double doors, an additional plate must be fitted on the left-hand
leaf to enable the lock to engage with both leaves.
On WIND double door systems, the axis of the lock must be installed
32 mm to the right of the centre of the beam; on WIND LIGHT double
door systems, 78 mm to the right of the centre of the beam.
For single door systems, the lock must be installed on the side where
the leaf closes. To adjust the lock and check that it is correctly positio-
ned, close the leaves against each other, back off the screws that fix
the plate of the lock to the beam, centre the lock so that it fits into the
holes provided on the carriage when the leaves are closed and then
firmly tighten the screws that fix the lock to the beam.
N.B. All lock adjustment procedures must be carried out with
the electricity supply switched off and batteries disconnected.
When adjusting, do retract the block by hand, to avoid bending
it, as this could cause malfunctions, with the risk that the car-
riages may collide.
The manual release device 900PA011 - 900PA011L must be in-
stalled beside the beam (on the left or right). Check that it is
operating correctly; when it is pulled, the lock must release the
leaves, allowing them to be opened by hand.
30
E
G
F
WIND LIGHT ELECTRIC LOCK BRACKET
Beam axis
WIND LOCK BRACKET
Beam axis
WIND LIGHT RELEASE DEVICE
SBLOCCO WIND LIGHT
Lock axis
32
Lock axis
78