Obligations Of The User; Intended Use - MAFA TMK 450 Manual De Instrucciones

User Manual English
Read this manual carefully before using the spray gun and retain it for future uses.
1 Introduction
The Release Agent Spray Gun TMK is suitable for the spraying of low viscosity media, such as
release agents, into molds, forging and the like.
The Release Agent Spray Gun TMK is a hand sprayer with separate operating Medium ( LIQ ) - and
Compressed Air (AIR) channels. The medium supply can be depressurized by self-priming, over
pressure pump or pressure vessels.
The rate of spread is controlled continuously by a screw.
The special design of the spray head high spray efficiency is achieved when merging air and fluid in
the spray head.
Operation
Simple, reliable handling of the device is done by pressing the lever in two stages:
1. Level: Blow Air
By lightly pressing the lever to the first pressure point blow air is released.
Cleaning of tools
Removing tinder and other casting residues
Distributing the releasing agents material and blow-drying
2. Level: Medium - Air Mixture
When fully pressed the lever, immediately atomizing / misting of the air-liquid mixture is effected.
Output:
Suction rate: at 4 bar = approx 1.1 liters / min.
The Release Agent Spray Gun TMK is a precision instrument, which for many years used as a
reliable tool in following the instructions.
2 Safety

2.1 Obligations of the user

The user is obliged to read the instruction manual prior to performing an operating or service
process.
Operating and service operations must not be performed when it is the person on the purpose, the
consequences and the exact implementation of each data item in the dark.

2.2 Intended use

The spray gun is suitable for applying thin fluid media, as samples release agents in molds, forging
and the like at room temperature. Never use aggressive media such as acids, alkalis, detergents,
chemicals, etc. for spraying. If in doubt, request the manufacturer if a spray product is suitable for
use with this gun.
page 9 from 60