Maintenance - SPARKY BM 1360CEPlus Instrucciones De Uso

ELECTRONIC RPM CONTROL
low rotation speed, further pressing the switch
results in smooth increase of the rpm to maxi-
mum upon reaching the extreme position.
ELECTRONIC SPEED PRE-SELECTION
The necessary speed can be pre-selected by
rotating the regulator dial 3 to the direction of
the arrow or to the mark "+" for increasing, and
to the direction opposite to the arrow or towards
the mark "-" for decreasing the speed, thus en-
suring optimum mode.
two-speed gear. Switching between the speeds
is performed by rotating the speed selector
marked on the switch, with the machine stopped
INSERTING OR REPLACING THE MIX-
ING PADDLE
Unplug the machine in case the plug has been
inserted in the socket.
Screw the mixing paddle 6 by hand in clockwise
direction.
harshly the mixing paddle 6 in anti-clockwise di-
rection. In case the mixing paddle has jammed,
RECOMMENDATIONS
The mixing paddle is still rotating for a while af-
ter the machines has been switched off.
If the rotating paddle touches a surface, a re-
bound may result.
Start the machine by slowly pressing the switch
mixing paddle has already been dipped into the
mixture.
OVERLOAD PROTECTION
Upon minor long overloads, the thermal over-
load protection actuates and switches the motor
off. To resume operation after cooling down for
approximately 3-5 min, switch the trigger off and
on again.
Current protection actuates upon large brief
overloads. It interrupts the supply and disables
the machine. To start operating the machine,
Original instructions
ACCESSORIES TO BE USED WITH
THIS POWER TOOL
- Mixing paddles with right wise rotation, M14
outer thread and Ømax140 can be used with
this power tool.
The delivery does not necessarily include the

Maintenance

WARNING: Always ensure that the
tool is switched off and unplugged before
attempting to perform inspection or mainte-
nance.
BRUSH REPLACEMENT
This power tool is equipped with auto-stop
brushes. When the carbon brushes are worn
out, the machine switches itself off. In this case
both brushes must be replaced simultaneously
with genuine brushes at SPARKY service centre
for warranty and post-warranty service.
GENERAL INSPECTION
Regularly inspect all fasteners and ensure they
are properly tightened. Should any of the screws
be loose, retighten it immediately to avoid haz-
ards.
If the replacement of the supply cord is neces-
sary, this has to be done by the manufacturer or
his agent in order to avoid a safety hazard.
CLEANING
and its ventilation slots clean.
Regularly check to see if any dust or foreign
matter has entered the ventilation slots and the
grills around the switches. Use a soft brush and/
or air jet to remove any accumulated dust. Wear
safety glasses to protect your eyes whilst clean-
ing.
Exterior plastic parts may be cleaned with a
damp cloth and mild detergent if necessary.
7
EN