Typical Installations; Removal Of Old Unit; Dishwasher Connection - Joneca ASD-1250 Manual De Instrucciones

*Dimensions
ASD-1250 28.5 cm / 11.2 in
DOUBLE BOWL CENTER OUTLET
SINGLE BOWL
*approx

1. REMOVAL OF OLD UNIT

TYPICAL INSTRUCTIONS, YOUR MODEL MAY VARY.
Before starting this step, turn off electrical
power at the circuit breaker or fuse box. Unplug
disposer.
If your old mount is the same type as the mount on your
new disposer, just reverse the assembly instructions found
in section 3. If your new mount system is different, follow
these instructions:
A. Have a container available to catch any excess water
/ waste from current disposer.
B. Use a pipe wrench to disconnect drain line where it
attaches to disposer discharge elbow (see 1A).
C. Remove disposer from sink flange by turning mount
ring to the left clockwise (see 1B). If you are unable to
turn the mount ring, tap on one of the extensions from
the ring with a hammer. Some mounting systems have
tubular extensions. Inserting a screwdriver into one
tube will provide additional leverage for turning the
mount ring (see 1B). Some disposers may require the
removal or loosening of nuts from the mount screws
(see 1C). Some disposers may require the removal of
a clamp.
1A

2. DISHWASHER CONNECTION

IF DISHWASHER IS NOT TO BE CONNECTED
GO ON TO SECTION 3.
If you are utilizing a dishwasher, complete the following
procedure.
A. Using a blunt instrument (steel punch or wooden
dowel), knock out entire plug (see 2A). Do not use a
screwdriver or sharp instrument. (When knockout
plug falls into disposer, you may remove it or grind it
up when the disposer is used. This will not damage
the disposer in any way, but may take some time to
grind).
B. Connect dishwasher hose
clamp. Make sure all plumbing connections are tight
and in accordance with all plumbing codes and
ordinances. Run water and check for leaks.

TYPICAL INSTALLATIONS

DOUBLE BOWL END OUTLET
*approx
1B
(see 2B) using hose
2
*approx
39.4 cm / 15.5 in
Caution: Be sure to support the disposer while
performing this step or it may fall when the mounting
ring is disconnected from the mounting assembly.
D. To remove remaining mount system from the sink,
loosen mount screws, push mount ring up. Under it is
the snap ring. Use screwdriver to pop off ring (see
1D). Remove mount ring, protector ring and gasket
from sink flange. Some mounts will require the
unscrewing of a large ring holding the sink flange in
place. Pull sink flange up through sink and clean off
old putty from sink.
E. Ensure that sink is clean and thoroughly dry.
IMPORTANT: This is a good time
to clean out the trap and drain
lines by running a drain auger or
plumber's snake before installing
your new disposer.
1C
2A
KNOCK
OUT PLUG
WOOD OR
METAL DOWEL
22 cm / 8.7 in
14.4 cm / 5.7 in
1D
* AIR GAP
RUBBER
HOSE
DISHWASHER
HOSE
DRAIN
DISPOSER
*Air gap may not be required for all
installations. Check local plumbing
codes.
16.7 cm / 6.6 in
10 cm / 3.9 in
2B