Nikken PIMAG AQUA POUR Manual De Uso página 3

SPECIFICATIONS
Dimensions
Weight
Water tank capacity
Magnet strength
Flow rate
Component life
TROUBLESHOOTING
Diameter: 9.8 in/24.9 cm
Problem: Water does not flow into supply tank.
Height: 21 in/53.3 cm
Cause: Air trapped in microsponge filter.
Solution: When water fill tank is full, press on microsponge, or pull upward on edge of
11 lb/5 kg
Fill tank 1.6 gal/6 liters
Problem: Microsponge filter is discolored.
Supply tank 2.6 gal/10 liters
Cause: Microsponge filter is dirty.
Solution: Clean or replace microsponge filter.
1,200 gauss
Problem: Water has a disagreeable taste or odor.
Cause: Poor water quality or filters need replacing.
With microsponge: approximately 4 minutes per liter (40 minutes for full tank)
Solutions: (1) Check quality of water used in system. (2) Clean or replace microsponge
With ceramic filter: approximately 30 minutes per liter (5 hours for full tank)
Microsponge prefilter: 5 years or 5,283 gallons (20,000 liters), whichever comes first*
Filter cartridge: 6 months or 528 gallons (2,000 liters), whichever comes first*
Ceramic prefilter: 2 years or 2,113 gallons (8,000 liters), whichever comes first*
Mineral Stones: 1 year or 1,056 gallons (4,000 liters), whichever comes first*
* Component life may vary, depending on water quality.
Nikken EPA Establishment No.: 75805-CA-001
Aqua Pour meets NSF/ANSI 42 standards for chlorine reduction
as verified and substantiated by test data.
microsponge, to release air bubbles. Make sure that microsponge is correctly seated
afterward.
filter. (3) Replace filter cartridge.
-3-