Epson L1800 Guia De Instalacion página 3

L1800
Start Here
1
Unpack
Note: The ink bottles and printer cables may be packed inside the product.
The included ink bottles must be used for product setup and are not for resale.
2
Fill ink tanks
Note: This product requires careful handling of ink. Wear plastic gloves
and place a sheet of paper under the ink tank unit when you fill or refill the
ink tanks, as ink may splatter. If ink spills, wipe it off immediately to avoid
permanent stains. If ink gets on your clothes or belongings, it may not
come off.
3
Load paper
Caution: Do not open the ink bottles until you are ready to fill the ink
tanks. The ink bottles are vacuum packed to maintain reliability. Never
place the product on its side after the ink tanks are filled.
Warning: Keep ink bottles out of the reach of children and do not drink
the ink.
Caution: Replace bottle cap tightly, or
ink may leak.
Press the power button and
wait until the power light
stays on.
Read these instructions before using your product.
During initial setup, make sure to use the ink bottles
that came with your product and use all of the ink.
Fill each tank with the correct ink color.
Check position.
Press and hold the
for 3 seconds until the
light starts flashing. Ink charging
takes approximately 20 minutes.
Ink charging is complete when the
power light stays on.
20 minutes
English
ink button
power