Metabo ASR 35 ACP Instrucciones De Manejo página 7

You must not perform any work other than that
described here.
In the event of misuse, improper operation or
unprofessional repair work no liability shall be
assumed by us for any damage incurred.
When the appliance is not in use, leave the hose on
the appliance to prevent dust accidentally
escaping.
Do not operate appliances or accessories under the
following conditions:
- If the appliance has recognisable damage
(cracks/breaks),
- If the mains connection lead is defective or shows
signs of cracking or ageing,
- If there is a suspected non-visible defect
(after a fall).
Do not point the nozzle, hose or tube at people or
animals.
If any foam or water egresses, switch off
immediately. Empty the container and, if need
be, the pleated filter.
Never sit or stand on the appliance.
Always set up the connection lead and hose so
there is no danger of tripping.
Do not pull the connection lead over any sharp
edges and do not kink or pinch it.
If the connection lead of the appliance is damaged,
it must be replaced by a special connection lead.
See the chapter on Repairs.
Always connect to a socket with protective contact.
Do not use any damaged extension leads.
Never insert or remove the mains plug with wet
hands.
Only pull on the mains plug, not on the lead.
The plug socket on the appliance may be used only
for the purposes defined in the usage instructions.
Do not leave the appliance unattended. If there is a
long work interruption, disconnect the mains plug.
The vacuum cleaner should not be used or stored
outside in wet conditions.
IMPORTANT - This machine must only be stored
indoors.
Acids, acetone and solvents can corrode the
appliance components.
Prior to any servicing work, clean the
appliance. Switch off the appliance after each
use and pull out the mains plug.
Steam cleaners and high-pressure cleaners must
not be used to clean the vacuum cleaner.
The inside of the cover must always be kept dry.
Mold contamination can result if the appliance is not
cleaned for an extended period, especially if used in
areas where foodstuffs are processed: Always
clean and disinfect the vacuum cleaner immediately
after use.
Never open the appliance outdoors during rain or
storms.
The appliance must not be operated in areas with
an explosion hazard.
Ensure that the vacuum cleaner is steady.
If the extracted air is discharged into the room,
ensure there is an adequate air change rate (L) in
the room. Observe the regulations that apply in your
country.
Caution! This appliance contains dust that is
harmful to health. Discharge and
maintenance operations (including disposal
of the dust collection containers) must only be
carried out by qualified specialists wearing
appropriate protective clothing and equipment.
Warning - general danger!
Caution! Do not use the appliance until you
have read the Operating Instructions.
WARNING - Operating staff must be provided with
appropriate instruction on how to use this vacuum
cleaner.
While the appliance is suitable for extracting
substances that pose a slight threat to health, it is
not appropriate for reducing wood dust in inhaled
air.
Dust from material such as paint containing lead,
some wood species, minerals and metal may be
harmful. Contact with or inhalation of the dust may
cause allergic reactions and/or respiratory diseases
to the operator or bystanders.
Certain kinds of dust are classified as carcinogenic
such as oak and beech dust especially in
conjunction with additives for wood conditioning
(chromate, wood preservative).
Observe the applicable regulations in your country
for the filter cartridges. The filter cartridges (made of
polyester) that are contained in the delivery comply
with dust class M (filters trap 99.9 % of all dusts as
of Ø 3 µm). HEPA filter cartridges see chapter11.
Accessories.
The total maximum permissible current
consumption (of dust extractor and connected
unit) must not exceed the value I
page 3). You can reduce the current
consumption of the vacuum cleaner with the
"Current Control" feature, and thus adapt it to
the on-site conditions. See chapter 6.3. If the
current consumption is too high, the vacuum
cleaner or the wiring can overheat and cause a
fire.
-----------------------------------------------------
SYMBOLS ON THE TOOL:
V ................ volts
A ................ amperes
Hz .............. hertz
W ............... watts
~
................ alternating current
ENGLISH en
(see table,
max
7