Tabla de contenido
Publicidad
Idiomas disponibles
Idiomas disponibles
en
ENGLISH
4. Overview
See page 2.
1 Current Control dial
2 Rotary switch On/Off/Automatic/AutoClean
3 Volume flow control display
4 Plug socket for power tool
5 PE filter bag *
6 Fleece filter bag *
7 Paper filter bag *
8 Upper part
9 Snap lock
10 Container
11 Cable holder (fold it back and use it to suspend
the mains connection lead)
12 Suction opening
13 Locking bar (for opening the hood to change
filter cassettes)
14 Locking knob
15 Motor protection filter
16 Filter cassette (according to IFA C)
* depending on equipment/not included in scope of
delivery
5. Initial Operation
Before plugging in, check that the rated
mains voltage and mains frequency, as
stated on the rating label, match with your
power supply.
5.1
Inserting a Paper Filter Bag or Fleece
Filter Bag
Paper filter bags (7) are not suitable for wet
vacuuming.
We recommend using paper and fleece filter bags
for:
- Applications, where small amounts of fine dust are
created (e.g. spot-grinding and grinding of paint
and lacquer coatings, extraction of drilling
applications with small diameters < 10 mm of
short duration, etc.).
- Use of machines, such as: routers, planers, small
grinding machines, etc.
When using a fleece/paper filter bag the filter
cleaning is non-functional.
Switch off the appliance, remove the mains plug
and open the snap locks (9). Remove the upper part
of the appliance (8) from the container (10).
paper
the slide, push it slightly towards the suction hose,
and pull it back after twisting).
Holding the new paper filter bag/fleece filter bag by
the flange, slide the bottom part over the suction
connection, and the top part over the latch pin.
8
On the inside of the
suction opening,
push the red rotary
slide with its
"triangle" marking
upwards. (To twist
Replace the upper part of the appliance on the
container, close the snap locks.
5.2
Inserting a PE Filter Bag
PE filter bags (5) are suitable for both wet and dry
vacuuming.
We recommend the use of PE-disposal bags for:
- Applications, where larger amounts of dust are
created (e.g. removal of plaster surfaces, spot-
grinding and grinding of screeds, etc.).
- Use of machines, such as e.g.: renovation milling
machines, renovation grinders, drywall grinders,
wall grinders etc.
When using a PE disposal bag, the filter cleaning
must be switched on (function AR / IR) for
corresponding materials (see recommendation).
Switch off the appliance, remove the mains plug
and open the snap locks (9). Remove the upper part
(8) from the container (10).
plastic
push it slightly towards the suction hose, and pull it
back after twisting).
Hold the PE filter bag (5) on the flange and, with its
opening, guide it first over the latch at the bottom
part of the suction opening, then fit up to the stop on
the suction opening.8
Spread out the PE filter bag (5) evenly across the
container floor. Arrange the edges of the PE filter
bag around the container rim so that the bag is firmly
clamped on all sides by the upper part (5), once
replaced.
6. The Appliance
6.1
Switching On/Off, Automatic, AutoClean
Select the required operating mode using the
switch (2):
Position "0":
• Vacuum cleaner is switched off
0
O
F
F
Position "I":
• Vacuum cleaner is switched on
I
A
• AutoClean* is switched off
O
N
Position "IR":
• Vacuum cleaner is switched on
R I
I
R
• AutoClean* is switched on
O
N
Position "AR":
• Automatic On/Off switch: The vacuum
A
R
cleaner is switched on or off by means of
a power tool connected to the mains
socket (4). (Note: The vacuum cleaner continues to
run for approx. 10 seconds after the power tool is
On the inside of the
suction opening,
push the red rotary
slide with its "circle"
marking upwards.
(To twist the slide,
Publicidad
Tabla de contenido
