Level 1 Operator Parameters - ero electronic ELK Guía Del Usario

3.4.4.

Level 1 Operator Parameters

Operator level 1 is designed for day to day operation
so that the access to these parameters is not protected
by a pass code.
Press to step through the list of parameters. The
mnemonic of the parameter is shown in the lower
display.
Mnemonic Scrolling text and Description
WRK.OP WORKING OUTPUT The active output value
WRK.SP WORKING SETPOINT
The current setpoint value
SP.SEL SETPOINT SELECT
Select setpoint 1 or 2 (SP1 or SP2).
A.TUNE AUTOTUNE automatically sets the control
parameters to match the process
characteristics.
REC.NO CURRENT RECIPE NUMBER
Select the recipe to recall (1 to 5)
T. ELAP ELAPSED TIME Timer time passed
T.REMN TIME REMAINING Timer time remaining.
LK.AMP Leakage Current
Current measured in OFF state
LD.AMP Load Current
Current measured in ON state
Part number HA028438. Issue 3.0.
After five seconds a scrolling text description of the
parameter appears.
The value of the parameter is shown in the upper
display. Press
key is pressed for 30 seconds the controller returns to
the HOME display
The parameters that appear depend upon the functions
configured. They are:-
Read only. Shown when the controller is in AUTO or OFF mode.
Read only. Shown when the controller is in MAN or OFF mode.
Alterable.
Off
On
Alterable. If a recipe is selected which has not been previously
loaded 'Fail' will be shown
Read only
Alterable. 0:00 to 99.59 hh:mm or mm:ss
Read only. Shown when the CT current measurement is
configured.
Read only. Shown when the CT current measurement is
configured.
Oct-05
▲
▼
or to adjust this value. If no
Availability
Disable
Enable
31