Special Safety Instructions
• Do not insert the device further than the thin tip of the shearing blade up your
nose!
• Do not use the device if the shearing blade holder, the shearing blade or the
inner blade are distorted or damaged! DANGER OF INJURY!
• This device is to be used exclusively for the cutting of nose and ear hair! Do not
use the device any other purpose!
• The shearing blade and the inner blade are precision-manufactured. Do not exert
heavy loads on it and avoid knocking!
• Keep the device away from humidity and liquids!
• Do not remove the shearing head during use! Switch off the device and remove
the battery before cleaning!
• Do not insert pointed objects in the shearing head.
• Open the battery compartment by pushing the cover down and away.
• Insert an AA type 1.5V battery with the positive pole (+) upwards in the battery
holder.
• Place the cover back on the battery compartment.
1. Take the protection cap off the shearing head.
2. To switch on the device shift the on/off switch towards the shearing head.
Warning: Do not switch on the device with the protection cap not mounted on
the device!
3. Insert the tip of the shearing head in your nose. Warning: remove only the hair
coming out of your nose and do not press the device inwards! Do not insert the
shearing head too deep and forcefully into your nose: risk of injury!
4. If pieces of hair remain in your nose after cutting, remove these simply by clea-
ning your nose.
5. Switch the device off after use with the on/off switch and open the battery com-
partment.
6. Take the cleaning brush out of the holder on the battery compartment cover.
Brush the shearing head in a star-shaped manner.
7. After cleaning insert the cleaning brush back into the holder and close the bat-
tery cover.
ATTENTION: Depending on the quantity of cut hair it is advisable to thoroughly
clean the device from time to time as described below in "Cleaning"!
Nose hair trimmer
Insert Battery
Putting into Service
GB
41