Connecting Up; Making Cable Connections; Connecting Audio Components - Pioneer A-A6-J Manual De Instrucciones

Connecting up

Chapter 2:
Connecting up

Making cable connections

Make sure not to bend the cables over the top
of this unit (as shown in the illustration). If this
happens, the magnetic field produced by the
transformers in this unit may cause a
humming noise from the speakers.
Important
• Before making or changing any
connections, switch off the power and
disconnect the power cord from the AC
outlet.

Connecting audio components

The number and kind of connections depends
on the kind of component you're connecting.
Follow the steps below to connect a CD player,
tape recorder, turntable or other audio
component.
Turntable
REC PLAY
OUT IN
TAPE TUNER
L
2
R
IN OUT
REC PLAY
AUDIO IN/OUT
Tape deck, etc.
1 Connect the analog audio outputs of your
CD player (or other component) to the CD
inputs on this amplifier.
Use a stereo RCA phono cable as shown.
3
CONTROL
OUT
SIGNAL
GND
L L
R R
AUX CD PHONO
This amplifier
1
OUT
R L
AUDIO OUT
CD player, etc.
02
D6
7
En