Disassembly - Unold 68860 Instrucciones De Uso

7. Select the desired pasta die and fasten it on the metal panel from the rear.
In this process pay attention to the notch on the outlet. The groove of the
die must be slid precisely into this notch.
8. Now slide the metal panel onto the threaded pins that protrude from the
front cover.
9. Firmly press the metal panel onto the front cover and then screw the wing
screws clockwise onto the threaded pins. Note: Screwing the wing screws
firmly onto the threaded pins is important, otherwise dough will escape between
the front cover and metal panel.
10. Important note: For safety reasons the lid has a locking mechanism. To take
off the lid, first press on the "Öffnen" (Open) button. The locking mecha-
nism disengages, the lid can be removed.

DISASSEMBLY

Always unplug the appliance from the electrical outlet before you take the
appliance apart.
1. To take off the lid, first press on the "Öffnen" (Open) button. The locking
mechanism disengages, the lid can be removed.
2. Unscrew the wing screws of the panel by turning them anti-clockwise and
take off the panel.
3. Take off the metal panel and detach the pasta die. Now you can detach the
front cover. Pull the kneader out of the kneading container.
Copyright UNOLD AG | www.unold.de
37