Delta JT360 Manual De Instrucciones página 11

3. Using the supplied wrench (or a 14 mm socket
wrench), fasten the jointer to the top of stand using
the three M10.2 lockwashers and three special
studs. Two of the special studs are shown at (D) Fig.
10. These are for the infeed end of the machine. The
other special stud is shown at (D) Fig. 11, for the
outfeed end of machine. Fully tighten the studs at
this time.
4. Once the jointer is completely secured to stand,
stand the machine upright. (Jointer is shown upright
and fully assembled in Fig. 11A.)
5. Push downward on the top of jointer until the stand
adjusts to the floor surface. Then using the supplied
wrench, tighten all stand hardware.
Fig. 10
Fig. 11
Fig.11A
11 - English
D
D