Troubleshooting Guide; Disposal Information - MIRKA AROS-B 150NV Instrucciones De Manejo

The Bluetooth® word mark and logos are registered trademarks owned by the Bluetooth SIG, Inc and any use of such
marks by Mirka Ltd is under license Other trademarks and trade names are those of their respective owners
Compliance with the radio regulations in North America has been verified in accordance with FCC Part 15 subpart B
and C, RSS-GEN, RSS-247 and FCC §15 247
Maintenance
Always disconnect the power before maintenance!
Only use original Mirka spare parts!
Replacing the backing pad
1 Hold the spindle with fingers
2 Turn the backing pad counterclockwise to remove it
3 Fit and tighten the new backing pad
Further service
Servicing must always be performed by trained personnel To keep the tool warranty valid and ensure optimal tool
safety and function, servicing must be carried out by a Mirka authorized service center To locate your local Mirka
authorized service center, contact Mirka Customer service or your Mirka dealer

Troubleshooting guide

Symptom
No light from sander right LED when
trigger is pressed.
The right sander LED is red and the
sander slows down to 4,000 rpm or
stops when sanding.
The right sander LED is red and rpm is
slightly reduced.
The left LED is red and the sander is not
running.

Disposal information

DANGER: Disposal guidelines for old appliances Render redundant power tools unusable by
removing the power cord Only for EU countries Do not dispose of electric tools along with household
waste According to European Directives 2002/95/EC, 2012/19/EU + 2003/108/EC on waste electrical
and electronic equipment and its implementation under national law, electric tools that have reached
the end of their life must be collected separately and taken to an environmentally compatible
recycling facility
Possible cause
Battery pack not properly attached to the
sander
Battery totally empty
Temperature too high in the sander Heavy
load for too long
Too heavy short-term load
The battery voltage is too low
Mirka® AROS-B 150NV & AOS-B 130NV • 32 mm (1 ¼") • 10.8 V
Solution
Insert the battery properly
Charge the battery
Reduce the load on the sander for some
time and the sander will speed up again
Use lighter load or wait a moment and the
LED will automatically change to green
Charge the battery
en | us • ca
195