Hoses And Fittings; Hose Connections; Typical Setup - Greenlee H6510A Manual De Instrucciones

Hoses and Fittings

Installation and Maintenance
See publication 99930323, SAE J1273
(Hose and Hose Assemblies).
Replacement
See a Greenlee Utility catalog or Greenlee Utility
publication 99910322, Low Pressure Quick Couplers,
Adapters and Hoses.

Hose Connections

Tool Port Identification
Three methods are used to identify the pressure and
return ports of Greenlee Utility tools. Match the mark-
ings on your tool to this table.
Pressure Port
P
In
9/16"–18 O-ring Boss
(smaller port)

Typical Setup

Greenlee / A Textron Company
Return Port
T
Out
3/4"–16 O-ring Boss
(larger port)
Connecting Hoses
1. Move the flow lever on the hydraulic power source
to the OFF position.
2. Stop the hydraulic power source.
3. Connect the return hose to the return port on the
power source, then to the return port on the tool.
4. Connect the pressure hose to the pressure port on the
tool, then to the pressure port on the power source.
Disconnecting Hoses
1. Move the flow lever on the hydraulic power source
to the OFF position.
2. Stop the hydraulic power source.
3. Disconnect the pressure hose from the power
source, then from the tool.
4. Disconnect the return hose from the tool, then from
the power source.
5. Install dust caps over the ports to prevent
contamination.
7
4455 Boeing Dr. • Rockford, IL 61109-2988 USA • 815-397-7070
Impact Wrench