Specifications - Greenlee HW3 Manual De Instrucciones

Specifications

Impact Wrench
Type of Hydraulic System .............................Open-center
Hydraulic Pressure Port ...9/16–18 UNF SAE O-ring Boss
Hydraulic Return Port ........3/4–16 UNF SAE O-ring Boss
Output @ 30.3 l/min (8 gpm)
RPM (no load) ...................................................... 2800
Impacts per Minute (no load) ............................... 1300
Torque @ 37.8 l/min (10 gpm) .......... 1742 Nm (1285 ft-lb)
Drive Size ..............................................3/4" square drive
Vibration Level ................................................... 15.3 m/s
Noise Level ..........................................................120 Lwa
Mass/Weight ........................................... 4.76 kg (10.5 lb)
Length ........................................................236 mm (9.3")
Width ..........................................................107 mm (4.2")
Height .......................................................300 mm (11.8")
Hydraulic Power Source
Do not exceed the following hydraulic power source
maximums:
• Hydraulic flow: 46 l/min (12 gpm)
• Pressure relief: 138 bar (2000 psi)
• Back pressure: 13.8 bar (200 psi)
Failure to observe this warning could result in severe
injury or death.
Type of Hydraulic System .............................Open-center
Flow
Minimum ......................................... 15.1 l/min (4 gpm)
Recommended .............18.9 to 30.3 l/min (5 to 8 gpm)
Maximum ......................................... 46 l/min (12 gpm)
Filtration .............................................10 Micron (nominal)
Pressure Relief Setting ........................ 138 bar (2000 psi)
Back Pressure (maximum*) .................. 13.8 bar (200 psi)
* 13.8 bar (200 psi) is the maximum agreed standard back pressure
for the HTMA (Hydraulic Tool Manufacturers Association).
Greenlee Utility tool will operate satisfactorily at this standard.
Greenlee / A Textron Company
Hydraulic Power Source (cont'd)
1. Maximum hydraulic fluid temperature must not
or closed-center
2. Hydraulic flow must not exceed 46 l/min (12 gpm).
3. Pressure relief valve setting must not exceed
2
Hydraulic Schematic
Recommended Hydraulic Fluids
Use any non-detergent, petroleum-based hydraulic
fluid which meets the following specifications or HTMA
specifications.
S.U.S. @
38 °C (100 °F) .............................................. 140 to 225
99 °C (210 °F) ........................................... 40 minimum
or closed-center
Flash Point ................................ 170 °C (340 °F) minimum
Pour Point .................................. -34 °C (-30 °F) minimum
7
HW3 Impact Wrench
exceed 60 °C (140 °F). A sufficient oil cooling
capacity is needed to limit the hydraulic fluid
temperature.
Install a flow meter in the return line to measure the
rate of hydraulic flow before using the tool.
138 bar (2000 psi) at your tool's maximum flow.
Locate the pressure relief valve in the supply circuit
to limit excessive hydraulic pressure to the tool.
FILTER
(10 MICRON)
RELIEF
VALVE
138 bar
RESERVOIR
(2000 psi)
CONTROL
VALVE
PUMP
POWER SOURCE
4455 Boeing Dr. • Rockford, IL 61109-2988 USA • 815-397-7070
COOLER
T
TOOL
FLOW METER
P