Faults; Technical Specifications - Qlima H 130 Instrucciones De Uso

3 Regularly clean the outside of the moisturiser with a slightly damp soft cloth.
4 Regularly clean the filter in the filler cap.

6. FAULTS

Fault
Indicator light fails to
light up when pressing
the control button.
Indicator light is on
and the device emana-
tes air but no mist.
Mist with unpleasant
smell
Mist level remains low
Mist is leaking from
the water reservoir

7. TECHNICAL SPECIFICATIONS

Model
Mains
Output voltage
Electrical consumption
Capacity water container
Maximum evaporation capacity
Dimensions mm (w x d x h )
Net weight
4
66
Cause
Missing power supply.
The water reservoir is empty
The water level sensor is not
being detected.
Water reservoir not clean
There are calcium deposits on
the ultrasonic element
The bottom of the water
reservoir is not connected
properly.
180x180x460 long
evaporation nozzle
Solution
Restore the power supply.
Fill the water reservoir
Position the bottom of the
water reservoir correctly so
that the sensor is detected.
Clean the level float.
Open the filler cap and leave
it open for 12 hours. Clean
the tank and fill it with clean
water.
Clean the ultrasonic element
and fill the water reservoir
with clean water.
Position the bottom of the
water reservoir properly.
H 130
220-240/50Hz
24V
16 W
1.6 l
130 ml
180x180x300 short
evaporation nozzle
1.25 KG