Technical Data - Husqvarna 435 Manual De Instrucciones

TECHNICAL DATA
Technical data
435 435e 440e
Engine
Cylinder volume, cu.in/cm 3 2,49/40,9 2,49/40,9 2,49/40,9
Cylinder bore, inch/mm 1,61/41 1,61/41 1,61/41
Stroke, inch/mm 1,22/31 1,22/31 1,22/31
Idle speed, rpm 2900 2900 2900
Power, kW/hp @ rpm 1,6/2,2 @ 9000 1,6/2,2 @ 9000 1,8/2,4 @ 9000
Emissions Durability Period according to California
125 125 125
Air Resources Board, h.
ignition system
Spark plug
Electrode gap, inch/mm
Fuel and lubrication system
Fuel tank capacity, US pint/litre
Oil pump capacity at 9,000 rpm, ml/min
Oil tank capacity, US pint/litre
Type of oil pump
Weight
Chain saw without bar or chain, empty tanks, Ib/kg
Chain/bar
Standard bar length, inch/cm
Recommended bar lengths, inch/cm
Usable cutting length, inches/cm
Pitch, inch/mm
Thickness of drive links, inch/mm
Drive sprocket type/teeth
Chain speed at max. power, m/sec
NOTE! The spark ignition system complies with
NGK BPMR 7A/ NGK BPMR 7A/ NGK BPMR 7A/
Champion RCJ 7Y/ Champion RCJ 7Y/ Champion RCJ 7Y/
Husqvarna PR 17Y Husqvarna PR 17Y Husqvarna PR 17Y
0,020/0,5 0,020/0,5 0,020/0,5
0,78/0,37 0,78/0,37 0,78/0,37
13 13 13
0,53/0,25 0,53/0,25 0,53/0,25
Not adjustable Not adjustable Not adjustable
9,3/4,2 9,7/4,4 9,7/4,4
13"/33 13"/33 13"/33
13-18"/33-46 13-18'733-46 13-18"/33-46
12-17"/31-43 12-17"/31-43 12-17"/31-43
0,325"/8,25 0,325"/8,25 0,325"/8,25
0,050"/1,3 0,050"/1,3 0,050"/1,3
Spur/7 Spur/7 Spur/7
17,3 17,3 17,3
the Canadian standard ICES-002.
Recommended original and replacement bar and chain combinations
Following is a list of recommended cutting equipment for the Husqvama chain saw models 435,435e and 440e.The
combinations of power head, bar and chain have been tested and found to be in accordance with the kickback and
vibration requirements of ANSI B175.1-2000.
The guide bar nose radius is determined by either the maximum number of teeth in the nose sprocket or the
corresponding maximum nose radius of a solid bar.
The following list is the chain saw manufacturers recommendations. There may be other combinations available, which
will also achieve kickback reduction.
As we are listing the maximum guide bar nose radius, you may use a guide bar with smaller nose radius than in our list.
For guide bars of the same length, all sprocket-nose guide bars of the same pitch and having the same number of
sprocket teeth may be considered to have equivalent kickback energy. A hard nose bar having the same length and nose
radius as a sprocket-nose bar may be considered to have equivalent or less kickback energy than the sprocket-nose bar.
1153135-49 Rev.6 2013-12-09 English - 31