Key To Symbols; Symbols On The Machine And/Or In The Manual - Husqvarna 435 Manual De Instrucciones

Ocultar thumbs Ver también para 435:
Tabla de contenido

Publicidad

Idiomas disponibles

Idiomas disponibles

KEY TO SYMBOLS
Symbols
on the machine
and/or in
the manual:
WARNING!
Chain saws can be
dangerous!
Careless
or improper
use
can result in serious or fatal injury to the
operator or others.
Please read the operator's
manual
carefully and make sure you
understand
the instructions
before
using the machine.
Always wear:
Approved
protective helmet
Approved
hearing protection
Protective goggles or a visor
Q
Both of the operator's
hands must be
used to operate the chain saw.
Never operate a chain saw holding it with
_k_
one hand only.
Contact of the guide bar tip with any
object must be avoided.
WARNING!
Kickback may occur when
the nose or tip of the guide bar touches an
object, and cause a lightning fast reverse
reaction, kicking the guide bar up and
towards the operator. May cause serious
personal injury.
@
.dl.=,_ _ ,,,,=.,,k_
Chain brake, activated (right) Chain
"_
_
brake, not activated (left)
CO)/O
Decompression
valve:
Press the
valve to reduce the pressure in the
,_
cylinder and make starting easier. You
should always use the decompression
DZu
valve when starting the machine.
mgnition; choke:
Set the choke control
in the choke position.This
should
I _\
_
I
automatically
set the stop switch to the
start position.
Adjustment
of the oil pump
+f_L
Other symbols/decals
on the machine
refer to special
certification
requirements
for certain
markets.
Switch off the engine before carrying
out any checks or maintenance.
NB,
i Voi
The start/stop
switch automatically
returns to run position. In order to
prevent unintentional
starting, the
spark plug cap must be removed from the spark plug
when assembling,
checking and/or performing
maintenance.
gloves.Always
wear approved protective
Regular cleaning
is required.
Visual check.
Protective goggles or a visor must be
I
I
worn.
Refuelling.
Filling with oil and adjusting oil flow.
The chain brake should be activated
when starting.
For Canada only:
Recommended
cutting
equipment
in this example:
- Bar length 16 inches
- Max. nose radius 10 Teeth
- Chain type Oregon 21LP
_
_
MaXlOT
Other approved bar and chain
combinations
in Operator's Manual.
Measured
maximum kickback value with
brake for the bar and chain combination
on the label.
Measured
maximum kickback value
without triggering the brake, for the bar
and chain combination
on the label.
1153135-49
Rev.6 2013-12-09
English - 7

Publicidad

Tabla de contenido
loading

Este manual también es adecuado para:

435e440e

Tabla de contenido