Connect And Set Up A Home Network; Set Up The Wired Network - Philips HTS3541/55 Manual De Instrucciones

Note
•
To change the EasyLink control settings, press
( Home ), select [Setup] > [EasyLink] .
Set up the audio
If you cannot hear the audio output of a
connected device through your home theatre
speakers, check that you have enabled Easylink on
all the devices (see 'Enable EasyLink' on page 8 ) .
Then, set up the EasyLink audio control.
1
Press ( Home ).
2
Select [Setup] , and then press OK .
3
Select [EasyLink] > [System Audio Control]
> [On] .
•
To play the audio from the TV speakers,
select [Off] and skip the following steps.
4
Select [EasyLink] > [Audio Input Mapping] .
5
Follow the onscreen instructions to map the
connected device to the audio inputs on your
home theatre.
•
If you connect your home theatre to the
TV through an HDMI ARC connection,
make sure that the TV audio is mapped
to the ARC input on your home theatre.
Connect and set up a home
network
Connect your home theatre to a home network
with Internet access and enjoy:
•
YouTube leanback
•
Picasa web albums
•
BD-Live applications
•
Software update
Caution
•
Familiarise yourself with the network router
and networking principles. If necessary, read
documentation that accompanies the network
components. Philips is not responsible for lost,
damaged or corrupt data.
10
Before you start
•
For software updates, make sure that the
network router has access to the Internet with
high-speed connection and is not restricted by
fi rewalls or other security systems.
•
Make the necessary connections described in
the quick start guide, and then switch the TV
to the correct source for your home theatre.

Set up the wired network

What you need
•
A network cable (RJ45 straight cable).
•
A network router (with DHCP enabled).
LAN
1
Using a network cable, connect the LAN
connector on your home theatre to the
network router.
2
( Home ).
Press
3
Select [Setup] , and then press OK .
4
Select [Network] > [Network Installation]
> [Wired (Ethernet)] .
5
Follow the onscreen instructions to complete
the setup.
• If connection fails, select [Retry] , and
then press OK .
6
Select [Finish] , and then press OK to exit.
•
To view the network settings, select
[Setup] > [Network] > [View Network
Settings] .
www
EN