S.R.Smith WetDek Instrucciones Para La Instalacion Y Para El Usuario página 2

INTRODUCTION
The WetDek is designed for use as a residential splash pad. Proper installation, use, and maintenance
are essential for optimal performance and to reduce the risk of accident or injury. These instructions are
developed and intended for use with either the stand alone or poolside versions of the WetDek with 6, 9,
or 12 nozzles.
Check entire box and inside all packing materials for parts. Before beginning assembly, read the
instructions and identify parts using the figures and parts listed in this document. It is critical that all
parts be carefully inspected by the installer prior to installation to ensure that no damage occurred in
transit and that a damaged part is not used. Proper installation cannot be overstressed, as improper
installation voids S.R. Smith's warranty and may affect the safety of the user.
WARNINGS
This unit must be hardwired only to a supply circuit that is protected by a ground
fault circuit interrupter (GFCI).
provided by the installer, and must be tested before each use. Consult GFCI manufacturers' instructions
for correct testing and operation. A bonding lug has been provided on the outside of the electrical control
box. The lug permits the connection of No. 8 AWG solid copper bonding conductor between the controller
and all other electrical equipment and exposed metal in the vicinity. ALL ELECTRICAL CONNECTIONS
MUST COMPLY WITH NATIONAL ELECTRIC CODE, AS WELL AS ANY APPLICABLE LOCAL
CODES. A LICENSED ELECTRICIAN MUST BE USED FOR ALL ELECTRICAL CONNECTIONS.
The custom circuit board in the WetDek AquaDirector Controller has been tested before leaving
the manufacturing plant. A BLOWN CIRCUIT BOARD IS NOT COVERED UNDER THE WARRANTY
OF THIS PRODUCT. It is important to have a licensed electrician install the AquaDirector. Also, it is
important that they read the instructions provided here and the wire diagram in the controller to insure that
the circuit board is not damaged.
DANGER – RISK OF ELECTRICAL SHOCK.
surfaces. A WetDek may be installed within 5 feet of metal surfaces if each metal surface is permanently
connected by a minimum No. 8 AWG solid copper conductor that is bonded to the control box. Do not
permit any electrical appliance such as a light, telephone, radio, or television within 5 feet (1.5m)
of a WetDek.
EXTREME CAUTION – adult supervision required during use. Do not leave
children unattended around the WetDek.
cannot use the Wetdek unless they are supervised by a responsible adult at all times. Do not use the
WetDek if the drain cover or nozzles are broken or malfunctioning in any way. A broken drain cover can
cause severe injury so examination of drain before each use is critical. Insure before use that drain cover
is secured and that drain is functioning properly. Note: the WetDek is not intended to be a wading pool of
any sort; do not allow use if pooling or back up of water occurs.
CHEMICAL SAFETY – Play it safe with chemicals.
bromine or chlorine. There is risk of illness if the water is not properly sanitized. Follow all chemical
manufacturers' recommendations to insure proper sanitation. Always store chemicals according to the
manufacturer's label directions and keep them out of reach of children. The stand alone model reservoir
should be emptied at least every two months.
**IMPORTANT**
Such a GFCI is required by most building codes and should be
Install at least 5 feet (1.5m) away from all metal
To avoid accidents and injury, insure that children
2
Maintain sanitizer level of 3-5 ppm of