Beper 40.820 Manual De Instrucciones página 10

Body scale Use instructions
Operation
The scale should be placed on a hard flat surface. Never touch any other object.
Step directly on the glass surface of the scale, it will appear " HI " on LCD until a stable reading is
displayed. Otherwise you can tap the surface till LCD displays "0.0" then step on for weighing ope-
ration.
Put your feet evenly on the glass surface without moving and wait or impact your weighing accuracy.
If you remain standing on the scale after your weight has shown, your weight will continue to display
for 10 seconds and then turn off automatically.
If you step off of the scale immediately after your weight has displayed, your weight will continue to
display for 3 seconds before returning to zero and then turn off automatically.
While the scale is turn off, turn the scale over and press the only switch located on the back of it. The
scale will choose and remember weighing unit "kg"/"lb"/and " st " in turn.
NOTE: IF NOT IN USE FOR LONG TERM, MAKE SURE NO OBJECTS ON THE SURFACE OF
THE SCALE THEN TAP ON THE LOWER CORNER OF THE SCALE. THE SCALE WILL CALIBRA-
TE THE ZERO POINT TILL "0.0" APPEARANCE.
Cautions
The scale will be slippery when it is wet. Keep it dry!
This product can only be used by static pressure. To avoid breaking by striking, shocking or drop-
ping.
Clean your scale with a damp cloth but avoid water getting inside the scale. Do not use chemical
cleaning agents. The scale should not be soaked by water.
Keep your scale in a cool place with dry air instead of humid or hot place.
Keep the scale in horizontal position.
This scale can only be used for weighing human body. Do not use it for commercial purpose.
Treat your scale carefully. Do not drop it or jump on it.
TECHNICAL DATA
Power supply 1xCR2032 lithium (included)
For any improvement reasons, Beper reserves the right to modify or improve the
product without any notice.
The European directive 2011/65/EU on Waste Electrical and Electronic Equipment (WEEE),
requires that old household electrical appliances must not be disposed of in the normal
unsorted municipal waste stream. Old appliances must be collected separately in order to
optimize the recovery and recycling of the materials they contain, and reduce the impact on
human health and the environment. The crossed out "wheeled bin" symbol on the product
reminds you of your obligation, that when you dispose of the appliance, it must be separa-
tely collected.
10