Installing The Battery Pack; Turbo Function - ardistel BLACK FIRE hardcore Manual De Instrucciones

Important: You may need to re-sync your controller after a PS3 rmware system update. If so,
please follow the above steps in 3.1.
3.3. To use the controller with your PS3™ system as a wired controller, please follow the
steps below:
EN
• First, remove the battery pack included (VERY IMPORTANT). Open the battery
compartment on the back of the controller using the release button of the battery cover in
front of the controller. Take out the battery and make sure that you store it in a safe place.
Place again the battery cover and use the release button to lock it.
• Next, make sure your PS3™ system is turned on.
• Plug the USB-miniUSB cable included within the controller miniUSB connector and also in
a free USB slot from your system, all 4 LED indicators will flash at the same time.
• Finally, press the HOME button and a player number (from 1 to 4) will be automatically
assigned and its matching LED indicator in the controller will be turned and will remain on.
• Now you can use the controller with your PS3™ system as a wired controller.
4. CHARGING THE CONTROLLER

4.1. Installing the battery pack

• This product works only with the battery pack included (also with the USB cable as I wired
device, see section 3.3). No need for batteries.
• To install the battery pack, open the battery compartment located at the back of the
controller and releasing the lock button of the battery cover, placed in front of the
controller.
• Insert the battery pack watching and observing properly the polarity.
• Finally, place again the battery cover and place back the release button in order to lock it.
4.2. Charging the controller
• In order to charge the battery pack from the controller, plug one side of the USB-miniUSB
included cable into the miniUSB plug from the controller, and the other side to a free USB
slot in your PS3™ system. NOTE: You must power on the PS3™ system to make it work; with
the system powered off, the controller will not charge even with the USB cable plugged.
• During the charging process, all 4 player LED indicators in the controller will flash to
indicate that the charging process has started.
• The controller will be fully charged once the LED indicators stop flashing and remain still.
• When the battery pack power is too low, one of the LED indicators will start flashing slowly
in order to indicate that you need to recharge the battery pack.
• You can play and charge simultaneously, but we recommend you not to use the controller
during the charging process in order to fully and charge in a faster way the battery pack.
Important: DO NOT USE BATTERY PACKS OR CHARGERS THAT AREN'T serviceable and
approved parts from Ardistel, because it may damage the device and the warranty will be
automatically cancelled. The warranty will not be applied to products provided by other
suppliers or if as a result of a misuse you damage the product. For the rst 3 charges please
charge the controller for 12h. So, the battery pack life will last longer.

5. TURBO FUNCTION

To activate the TURBO function in some of the controller buttons, you must follow the steps
below. Please note that you can activate the TURBO function only in the following 8 action
buttons: SQUARE, TRIANGLE, CIRCLE, X, L1, L2, R1 and R2.
11