Marsh 5HT Manual Del Propietário página 32

Maintenance
Cleaning the Slide
Spring and the
Actuating Pin
Figure K
Figura K
Cover Plate Screw
Vis de la plaque de couverture
Tornillo de la tapa
25006/00042 Rev I
7. Replace the brush tank and the pressure pad.
8. Replace the cover weight.
9 Plug in and turn on the machine. It is now ready for use.
The slide spring and the actuating pin are located on the left side of the machine,
beneath the left cover plate. (See Figure K)
1. Remove the cover plate by removing the three screws.
2. The slide spring is attached to the actuating pin. Apply a small amount of grease to
the clear section of the pin where the spring is attached.
3. Replace the cover plate.
Apply Grease Here to theActuating Pin
Point de graissage de la goupille d'actionnement
Lubrique el pasador de mando aquí
Slide Spring
Ressort de coulissement
Resorte deslizante
Actuating Pin
Goupille d'actionnement
Pasador de mando
31