Service And Adjustments - Agri-Fab 45-02114 Manual Del Usuario

Esparcidor de amplio alcance de remolque
Tabla de contenido

Publicidad

Idiomas disponibles

Idiomas disponibles

MAINTENANCE
CHECK FOR LOOSE FASTENERS
1. Before each use make a thorough visual check of the
spreader for any bolts and nuts which may have loosened.
Retighten any loose bolts and nuts.
CHECK FOR WORN OF DAMAGED PARTS
2. Check for worn or damaged parts before each use.
Repair or replace parts if necessary.
CHECK TIRE INFLATION
3. Check if tires are adequately inflated before each use. Do
not inflate beyond maximum recommended pressure.
CLEANING
CAUTION: DO NOT inflate tires beyond the
maximum recommended pressure printed
on side of tire.
4. Rinse inside of hopper and exterior of spreader and dry
off before storing.
LUBRICATE (See figure 14.)
5. Lightly apply automotive grease as needed to the
sprocket and gear.
6. Oil the nylon bushings on the vertical sprocket shaft
and on the axle at least once a year, or more often as
needed.
7. Oil right hand (idler) wheel bearing at least once a year
or more often as needed.
OIL
FIGURE 14
STORAGE
1. Rinse inside of hopper and exterior of spreader and dry
off before storing.
2. Store in a clean, dry area.
OIL
GREASE
ENGLISH

SERVICE AND ADJUSTMENTS

1. If the axle, slotted gear and sprocket assembly is
disassembled, mark down the positions of the parts as
they are removed. T he drive wheel and sprocket positions
in relation to the slotted gear determine which direction
the spreader plate will spin. Be sure to reassemble them
in their original positions. (Refer to figure 4 on page 5.)
Use shim washers (Ref. no. 21 on pages 18 and 19)
as needed for minimum backlash. Add grease to gear
and sprocket.
2. If the agitator hairpin becomes damaged or worn it can
be replaced. See figure 15.
AGITATOR
HAIRPIN
FIGURE 15
9
SPROCKET
SHAFT

Publicidad

Tabla de contenido
loading

Tabla de contenido