Name And Address Of The Manufacturer - Weka 100.2021.00.10 Instrucciones De Montaje

Tabla de contenido

Publicidad

Idiomas disponibles
  • ES

Idiomas disponibles

  • ESPAÑOL, página 27
General
⇒All wood parts in Nordic spruce
Wall assembly
⇒28 mm thick tongue and groove logs
⇒Versatile design possible due to subsequent installation of windows and doors
Roof
⇒19 mm thick roof boards nailed to study roof purlins, roof covering in bitumen roof paper or bitumen
shingles.

3.2. Name and address of the manufacturer

Manufacturer:
weka Holzbau GmbH
Johannestr. 16
D-17034 Neubrandenburg
Tel.
Fax
E-mail info@weka-Holzbau.com
4. Product description
4.1. General functions and area of application
The cabins are intended exclusively for the storage of garden equipment etc. or as a place to relax for
a short while and enjoy your garden. You are not permitted to use the cabin as a residence or heated
accommodation.
4.2. Dimensions
You can find the dimensions on the views included in the pack.
4.3. Safety information
Selection of the substrate
The ground under the cabin should be level, horizontal and built up. If your cabin is located near
slopes and basements, you should consult a local builder. Otherwise, there may be a risk of collapse.
Built-up ground must be compressed to ensure that the cabin does not sink, otherwise damage may
occur. Any turf must also be removed.
Space requirements
The space required depends on the size of your cabin. The cabin must always be accessible from the
outside on all sides to allow for inspection, ventilation and protection against weathering. The space
required should be approximately 1.0 – 1.5 m larger than your cabin on all sides.
Safety information and warnings
In order to prevent accidents, we recommend that children be kept out of the direct vicinity during
assembly.
During assembly, children under the age of 14 should be kept at least 3 m from the assembly site.
The current occupational safety and accident prevention regulations are to be observed. Information
can be obtained from a builder.
The roof is only to be accessed on load-distributing boards.
When you are working on a roof, avoid the risk of falling by complying with the current accident
prevention regulations (e.g. scaffolding requirements, safety rails).
Agree the required measures and operating conditions with a local builder or competent work safety
authority. Always work with helpers!
Techn. Änderungen vorbehalten!
: (0049)-395 429080
: (0049)-395 4290883
 Copyright HRB 3662
11

Publicidad

Tabla de contenido
loading

Este manual también es adecuado para:

100.2024.00.10

Tabla de contenido