Connect Power Pack 100 W / 150 W - Schluter Systems LIPROTEC LT EK 24V30W, LIPROTEC LT EK 24V50W Manual De Uso

6.3 Connect power pack 100 W / 150 W

6.3.1 Connecting loads
In order to connect the 24 V loads to the power pack,
proceed as follows:
Lead the connection cables of the LED strips, Bluetooth

receiver or the installation box to the power pack's
terminal box (see fig. B, item 2).
Make sure that the connection cable is not live. Also

make sure that the strands of the wire ends are soldered
or are given end sleeves.
Open the terminal box.

Lay the connection cable to the terminal box connectors.

In doing so, ensure correct polarity and tension relief
functionality. Also make sure that the design of the
connection cable and the connection to the connection
terminals comply with the local regulations.
Close the terminal box.

6.3.2 Connecting the mains voltage
In order to connect the power pack to the mains connection,
proceed as follows:
Attach the wires of the mains cable (L = phase, N =

neutral wire, PE = ground wire) correctly to a mains
cable.
Make sure that the ground wire is functionally connected.

Directions for use for the power pack
EN
Connection
55